Electronics Forum | Thu Sep 13 11:01:39 EDT 2007 | cyber_wolf
Fuji specs out Omega 66 grease for the solenoid sliders on older CP machines. These solenoids run hot. Its interesting to me that this grease is designed for extremely low temperature applications. Whats up with that ? http://www.omegaoil.co.jp/ind
Electronics Forum | Thu Jul 31 14:07:44 EDT 2014 | kurtiss
I found a bad solenoid and replaced it solenoid 15 on station 11. The machine is still erroring out. I also checked the holders and sensors and they seem to be ok. This error occurs when ever the machine tries to change nozzle sizes on any holder. T
Electronics Forum | Fri Dec 21 09:36:48 EST 2007 | mulder0990
Measure the O-ring if you are able to get to it and take the specs to any industrial supply shop, online or otherwise, and see what their price is. I repair Fuji feeders, so I cannot really help on the size but that is how I get the O-rings for my f
Electronics Forum | Fri Jan 18 07:01:41 EST 2008 | cyber_wolf
Hi, The solenoid that sits on top of the vacuum generator on my Fuji bare board loader is croaking slowly. Fuji will only sell me the entire generator assy. which cost more than I paid for the loader. The only markings on the solenoid are DC24V 540
Electronics Forum | Tue Jan 09 03:12:59 EST 2001 | Avichai ramot
Hello I need a part for CP-IV3. can enyone help me find the part ergently. THE PART IS: H1068Z pcd2413-02-D24SP VALVE SOLENOID "KURRODA" BEST REGAREDS
Electronics Forum | Wed Nov 03 12:57:28 EDT 2010 | adrianam
I need some help with the following alarm appeared on Fuji FCP4-3 : ,,Servo Amplifier alarm on X, Y, C, Z axis". When I push the reset button, remain ,,Servo Amplifier Alarm on D, F theta axis". All the sensors and solenoid it were checked and is OK
Electronics Forum | Sat Mar 20 09:04:39 EST 1999 | Stefan Witte
| Here is my question. We have several fuji CP's in our shop, every once in a while the first couple of parts placed are off the pads. When we move the parts further down in the sequence they are fine. What is going on? Has anyone had this problem an
Electronics Forum | Mon Sep 14 11:45:08 EDT 1998 | John McMasters
Has anyone used Fuji's rubber tip nozzles for the IP3? Are they O-ring type or suction cup? I'm having trouble picking up Ompacs due to the top of the part not consistently being flat. Any actual experience with these $1100 nozzles would be appreci
Electronics Forum | Sat Dec 13 08:03:46 EST 2003 | Stefan Witte
The only part, which could cause component misplacement on the rotary heads of the Siplace machine is the vacuum valve. I don�t know the official name in the part catalog, but I use to name it plunger. The plunger is moved in and out by a miniature s
Electronics Forum | Wed Oct 29 20:58:31 EDT 2008 | rmitchell
Hi, Our Fuji CP6 table is rising up abruptly when it unloads a pcb after populating it. It makes a clunking noise much louder than before. I don't see anything that has changed or gets in the way as far as the table rails lining up with the exit c
