Electronics Forum | Thu Nov 09 21:29:06 EST 2000 | eva
Hello Omar, What software did you use before you installed FujiCam? What's the difference between theta for IP2 and CP6 ? Regards, Eva
Electronics Forum | Wed Jul 11 12:10:06 EDT 2012 | cyber_wolf
Q is theta related.
Electronics Forum | Wed Jul 11 12:49:49 EDT 2012 | cyber_wolf
There is probably a component stuck in the theta gears or it needs PM'ed
Electronics Forum | Thu Nov 04 06:46:19 EDT 2010 | adriana
We find the problem on Servo Pack for F theta axis .The component QM20TD-H Mediu power Switching is damaged! Many thanks!
Electronics Forum | Fri Jun 02 17:19:56 EDT 2000 | Big K
I am currently experiencing several problems with QFP's on one of our IP3's. The first problem is with QFP240 devices. We are experiencing a high reject rate with these parts when using vision type 100. What appears to happen is that the vision syste
Electronics Forum | Wed Nov 03 12:57:28 EDT 2010 | adrianam
I need some help with the following alarm appeared on Fuji FCP4-3 : ,,Servo Amplifier alarm on X, Y, C, Z axis". When I push the reset button, remain ,,Servo Amplifier Alarm on D, F theta axis". All the sensors and solenoid it were checked and is OK
Electronics Forum | Thu Nov 09 13:26:08 EST 2000 | omar_verdugo
Somebody can help me with this problem.I already have installed the version of fujicam 1.2 but the machine interface that come with this don't work propertly this have a little problem with the rotation of theta is not the same with the theta assingn
Electronics Forum | Tue Dec 06 19:44:10 EST 2011 | comando
Hello every one! I need help with a misaligned theta at plcc44, the machine is a IP3 smd3, firmware 2.99, vision card 4400 and both camera type YD2048N on label but in Proper data is set 2 (I don't know if this is right) we use Fuji flexa, Back Lig
Electronics Forum | Fri Nov 10 10:39:43 EST 2000 | omar_verdugo
Hello Eva. I was using Fujicam 1.1 and i had a problem with the theta is in the shape library for example all the drawings are on 0 degress like a in the part data and all that work fine with the anothers machines like a cp6, but when i use a ip2 i m
Electronics Forum | Mon Dec 18 21:23:13 EST 2006 | jgarver1
The spline shaft is bent. I have replaced a number of these over the years with the exact same symptoms. How is your placement? Your 180 degree placements should be skewed if the shaft is bent. 0 Degree placements are typically acceptable due to
winsouce.jpg)
