185 fuji vacuum pin results

Electronics Forum: fuji vacuum pin (Page 1 of 19)

Fuji CP6 vacuum valves

Electronics Forum | Mon Jul 13 08:12:58 EDT 2009 | cyber_wolf

Does anyone have a source for new Kuroda MDV235-P vacuum valves ?

vacuum break completion error

Electronics Forum | Tue Oct 11 04:40:38 EDT 2022 | kojotssss

There is special software for Fuji: Equipment Check, all statuss shown for I/0 .

vacuum break completion error

Electronics Forum | Sun Oct 02 10:40:10 EDT 2022 | omar08

Hi, I have this problem in NXT3 fuji machine . 80001919 vacuum break completion error. 88D40000 Placement (part rejection ) error

Fuji NXT I backup pin problems

Electronics Forum | Mon Mar 24 15:20:15 EDT 2014 | kojotssss

Hello for all People's .I have a question. I have a problems with backup pin placement.When x/y robot tried to set up pins: we got a problem- X=-0.200 and y=-0.880 To my mind ther are a problem with air cylinder and axis.Any solutions?! can you c

Placement of 32 pin QFN w/t ground pad

Electronics Forum | Wed Sep 30 13:10:49 EDT 2009 | spitkis2

Hi guys, Can someone please clarify whether adjustment of Z axis travel is a critical parameter during placement of QFN devices. If so, to within what tolerance? In other words, should a pick and place machine position a QFN down on the board so t

How to place pin supports the same everytime a board is ran?

Electronics Forum | Tue May 29 07:24:07 EDT 2012 | cyber_wolf

There were some issues with the older grid-lok systems that have been resolved in the newer designs. We run them in all of our printers and Fuji chip shooters. The only issue we see is that the air pressure may need adjusted on thin boards.

PCB Support Methods @ the Fuji.

Electronics Forum | Wed Sep 22 16:48:40 EDT 1999 | C.K.

Question for you SMT guru's out there. What is the best way to support boards on Fuji's CP6 machine's x-y table...particularly for 2nd side SMT where the support side already has parts... I am toying around with the following methods: 1.) Custom b

Re: PCB Support Methods @ the Fuji.

Electronics Forum | Wed Sep 22 16:51:05 EDT 1999 | C.K.

| Question for you SMT guru's out there. | | What is the best way to support boards on Fuji's CP6 machine's x-y table...particularly for 2nd side SMT where the support side already has parts... I am toying around with the following methods: | | 1.