Electronics Forum | Sun Aug 20 02:31:18 EDT 2006 | daxman
Last week, when we turned on our IP3, we received an error on our IP3, which read "Fatal Error with VP Turn Power Off" We had been running product the day before, and the day after we received this error. The function keys are locked and will not w
Electronics Forum | Thu Apr 11 21:20:04 EDT 2013 | dman97
Hello. I am having a problem with a CP3 machine. This machine decides every so often to kill 24v power to its self. At first I thought it was a bad 24V power supply, but I swapped it out and it still decides to occasionally kill its self. I also re
Electronics Forum | Wed Oct 25 11:25:12 EDT 2017 | paddyronan
Hi all, I have a recent issue with an IP3 machine. The machine cycles through normal power up routine. Then the video monitor and VME card shit themselves down and after a couple of minutes the CPU board powers down. However this is intermittent. Wh
Electronics Forum | Wed Jan 31 13:00:43 EST 2007 | bvdb
The continuing saga - we got the IP-1 communicating with the MCS16 again by replacing a couple of chips on the VME1152 CPU board and now it's working again but have a new problem. The machine stops about every other time when changing nozzles with a
Electronics Forum | Thu Jul 10 13:24:59 EDT 2014 | sargeredarmy01
Ok so here is where I am with everything. I pulled the cylinder and cleaned it out. Didn't find anything out of the ordinary inside. I set everything back up and tested it. Still nothing. I went into the I/O map and tracked down that input, I then
Electronics Forum | Sat Jan 20 23:48:55 EST 2007 | bvdb
Hi Al, Thanks for the suggestion. Yes, I should have said that the cable has been checked and another cable tested with the same results. In addition to the three wires that carry the transmit data, the receive data and the data signal ground, the
| 1 |
