Electronics Forum | Thu May 10 02:58:00 EDT 2018 | robl
Hi Dex, We're going back a few decades here, but... 1) can you treat it as 4 large leads - one rectangular block per side? 2) Is it failing on the coplanarity check set up or the basic vision? if Coplanarity, can you skip that check? 3) are you us
Electronics Forum | Thu May 10 08:15:06 EDT 2018 | kdexter0928
Rob, 1) I have not yet tried treating each side as a large lead. Thats an excellent idea and I will give that a try shortly here. 2) I have skipped the coplanarity check in attempt to get it to place so it is failing the basic version. 3) we are u
Electronics Forum | Wed Mar 11 12:23:08 EDT 2009 | rodrigo
I changed the satus B bit to disable the MTU (still on though). It doesn't wait for the MTU anymore but I get a Emergency and Door NG errors. The relay tripped. Is there a way to completely disable the MTU (leave it off) and power up the IP? This sho
Electronics Forum | Wed Mar 11 13:18:32 EDT 2009 | smellew
Even if you disable the MTU(see address 1005 to link out E-stop & address 1219 for the safety fence rear) the servo still needs to be replaced. SA6 is the faulty one, i'm sure there are many dealers who could supply you one. if you need further conf
Electronics Forum | Fri Mar 13 16:23:10 EDT 2009 | rodrigo
We're going to swap SA-4 and 6 but it is going to take a few days. Thanks for all the help. Follow up: We swapped SA-7 and SA6 (because SA-4 was different). The problem stayed with the original amp. so we're looking for a replacement. Our buyer is h
Electronics Forum | Mon Mar 09 17:42:56 EDT 2009 | smellew
ok Please power on the machine & confirmed that M1CP 2 is ok this is the breaker for the 35V & check M1cp1 now look at the drawings at address 1011 & check the axis ready relays Z1 11CS3x 151-GB Closed is ok if open see address 5402 Z1 servo amp is f
Electronics Forum | Mon Mar 09 13:07:52 EDT 2009 | rodrigo
Hi all, Our IP-2 stop working during production with a Servo NG error. Turning it on and off just goes back to the same thing or "Turn servo power on" error message. I was checking the power for the servo amps and I found a 35VAC line that is missin
Electronics Forum | Tue Mar 10 14:11:42 EDT 2009 | rodrigo
Ok I checked and here are the results... Z1 11CS3x Green LED on Q1 11cs4x Green LED on Z2 12cs3x Green LED off (This is the relay I mentioned in my original post). Q2 12cs4x Green LED on M1CR4x Green LED off The servopack SA-6 is the one with the
Electronics Forum | Tue Mar 10 15:24:28 EDT 2009 | smellew
Rodrigo, I'm not available tonight, if you have a new servo amp change it pay special attention to the jumper settings there are 2 types of amp you can fit see drawings for info. the original info you posted, re the MTU i believe is not related but
Electronics Forum | Tue Sep 14 17:15:30 EDT 2010 | daxman
Hi Steve, I don't have any experience with CP2's. Sorry .. hazarding a guess though... if they use the analog servo amps like they do in the CP4's, they had a bunch of trimmer pots on them. There is a procedure to zero them using the mecca check mod
