Electronics Forum | Wed Dec 20 07:08:51 EST 2006 | cyber_wolf
We have had this happen. The Z-ball screws do go bad in IP3's. We replaced the ball screw and the problem went away. As mentioned improper belt tension will cause the servo to make loud noises. But if you say the movement is rough, then the ball scr
Electronics Forum | Wed Apr 13 15:34:27 EDT 2011 | wingding
I am looking for a FUJI CP3 Y Ball Screw. P/N: W1505-29P-C5Z10. I have contacted ibe, SMT Research, and SMT Parts. FUJI has one but it is $3,000 dollars, in the end $3,000 may be a deal. But for now I'm still looking. Any assistance would be greatly
Electronics Forum | Wed Dec 20 17:03:50 EST 2006 | aj
By the way , changing the ball screw will also sort your problem out because you will have to carry out the Z-axis setup ( belt tension etc ) as part of the change. so it is worth a shot to carry out the setup and see how it goes! you will have nothi
| 1 |
winsouce.jpg)