Electronics Forum | Mon Jun 19 14:14:12 EDT 2000 | pr
SMTRESEARCH.COM OR WPSALES are also options. There are lots of them out there who will supply just the discs, new nozzles, or do retips on your nozzles (cheaper) and all I've dealt with are cheaper than Fuji. As Kevin says your disc's need to be cons
Electronics Forum | Tue Sep 15 07:48:46 EDT 1998 | Wayne Bracy
| Has anyone used Fuji's rubber tip nozzles for the IP3? Are they O-ring type or suction cup? I'm having trouble picking up Ompacs due to the top of the part not consistently being flat. Any actual experience with these $1100 nozzles would be appre
Electronics Forum | Fri Mar 13 00:11:16 EST 1998 | Rob Cass
| | Has anyone had any success in repairing Fuji CP nozzles in house? Removing bent press fitted nozzle and replacing. Any input would be appreciated, please no solicitation from repair shops | Rob, | What model of CP? Mr. Kooki CP4 and 6 Mr. Kooki
Electronics Forum | Tue Jun 28 19:56:20 EDT 2005 | matjen
I am in the process of searching for anyone that does repair on fuji cp6 nozzles .7 & 1.0 mainly, We have an abundance of bent and broken nozzles that I would like to get repaired rather than throwing out so if anyone has information on this please
Electronics Forum | Wed Jun 29 03:47:12 EDT 2005 | fastek
I'm confused. Aren't Fuji nozzles like $20 each? Why bother? I would hope you understand that a nozzle not properly repaired could cause $50 worth of rework in about a minute after you installed it. Stepping over dimes to pick up pennies comes to min
Electronics Forum | Wed Mar 18 22:52:15 EDT 2015 | mdang
What nozzle size do you use to place 01005 on Fuji CP8 machine? The smallest nozzle size on the CP8 is 0.4mm. Could we use this nozzle to place 01005 since the size of 01005 pacakge is 0.4mm x 0.2mm. Thank you for your help, -Michael
Electronics Forum | Tue Feb 15 06:53:50 EST 2005 | cyber_wolf
It seems that every time we do maintenance on our CP6 windmills, we have a lot of problems with nozzles sticking up inside the holders. It seems to happen for a while, then it goes away after we run for a bit. We follow the Fuji maintenance procedure
Electronics Forum | Thu Sep 23 18:56:42 EDT 2010 | slwolbert
Greetings all: I may have a simpler issue going on with this Fuji IP2 machine I'm struggling with. IP2 will boot and zero set, but if production is to be done, during the nozzle check sequence it gives a check nozzle message. This is due to the no
Electronics Forum | Mon Jul 26 18:27:59 EDT 2010 | fredc
We make these also. Our nozzles are available as medium hard from heat treated bar (32 to 38RC) or very hard made from Bearing Quality 416 stainless. We can retip your Fuji nozzles also. www.nozzlesupply.com
Electronics Forum | Sun Sep 11 02:33:07 EDT 2011 | johndoe0222
We are using Fuji CP iv-3 and keep getting "Nozzle size alarm and Nozzle position error." I was wondering what is wrong and how do I fix these errors? Thanks
winsouce.jpg)