Electronics Forum | Fri Aug 01 09:21:28 EDT 2014 | jimmyboz
Does it error during nozzle center check, if so, manually switch all holders to small, try center again. It should do about 8 small nozzle centers before error, if so this helps rule out the 10th station, if not check the 10th.
Electronics Forum | Wed Sep 11 01:17:59 EDT 2002 | Brian Sloth Bentzen
Hi Steve. My Fuji CP6 is model 643 and are 3 years old, maintained and upgraded with the newest software along the way. And, actually it was Fuji Japan that gave in, not Fuji America. Fuji Japan tested our components and found the same problem and
Electronics Forum | Thu Mar 03 11:10:20 EST 2005 | Dougs
I'm telling you i've bought the nozzles wound the wrong way and it helped, no more probs with nozzles sticking, i'd tried buying fuji nozzles, checked all my component heights, set Z0 properly, checked shaft heights, set up st1, etc etc but the new s
Electronics Forum | Wed Jun 29 03:23:10 EDT 2005 | dougs
We used to use a company in the uk that did this, we stopped as the results were never that good, i think the company stopped offering the service as well as no-one else wanted to have their nozzles repaired, it's best to get new nozzles in and make
Electronics Forum | Wed Jan 31 14:58:13 EST 2007 | pr
Is it the same nozzle every time? I would check that the shaft is hitting dead center (it could be binding)on the nozzles (especially if it only happens on 1 nozzle). Also check the rollers on the shaft (that hold the nozzle) and make sure they line
Electronics Forum | Mon Mar 07 18:41:13 EST 2005 | jimmyb
--IE, Funny.--- I "remember" kinda, from the early CP6 years, things about the springs. The early Fuji springs had sharp ends, and if you spun the nozzle, prior to final attachment, the opposite way it could stick, and if it was spun the right way,
Electronics Forum | Tue Jan 24 18:21:22 EST 2006 | fredc
I have some old Fuji windmills here and I checked the usefull travel. It is approxiamately 1.5mm, the nozzles are suposed to have .3mm "preload" wich will take away from the usable overtravel. The windmill I checked is a reject that from when we rebu
Electronics Forum | Mon Apr 09 22:39:53 EDT 2018 | stephenj37824
well, we have narrowed it down to the 12 nozzle Yamaha S20, the Fuji Aimex 3 and the Juki RS1. Waiting for the final quote from Fuji now. The Juki and Yamaha are within 10% of each other. It seems features and speed go to Yamaha between Juki and Yama
Electronics Forum | Wed Sep 16 10:11:17 EDT 1998 | Ben Salisbury
| Has anyone used Fuji's rubber tip nozzles for the IP3? Are they O-ring type or suction cup? I'm having trouble picking up Ompacs due to the top of the part not consistently being flat. Any actual experience with these $1100 nozzles would be appre
Electronics Forum | Fri Apr 10 05:14:01 EDT 1998 | Ben Salisbury
| | | | Has anyone had any success in repairing Fuji CP nozzles in house? Removing bent press fitted nozzle and replacing. Any input would be appreciated, please no solicitation from repair shops So far I havn't had any luck in doing this...but then