Electronics Forum | Thu Aug 07 09:37:38 EDT 2008 | cyber_wolf
How many out there are using Fuji XP243 machines ? What are your experiences? Good/bad ?
Electronics Forum | Fri Aug 08 08:01:29 EDT 2008 | mmjm_1099
I use a XP242 and like the machine but it does have limitations on vision system. I am unsure if those same limitations apply for the XP243. If you need a good reference of a tech on these machines call IBE, SMT Equipment and ask for Jim Bozak. When
Electronics Forum | Fri Jun 02 07:16:55 EDT 2006 | philips
hi Efren, 25k/month means this will come 1000 units per day(25days) so 500 for 1 shift, so by using following method u can easily produce ur target. MPM AP25 - XP-142 - XP142 - XP243 - VITRONICS reflow, this is the best method, by using optimastic pr
Electronics Forum | Fri Aug 08 09:11:44 EDT 2008 | nats
We have had one in our facility for 2 and 1/2 years. Running it 24/7 Monday - Friday and some weekends as well. Have not had one bit of trouble. Rock solid Fuji.
Electronics Forum | Tue Jun 06 23:52:52 EDT 2006 | saiwong
According to your low/mid volume production. I suggest you to use the Fuji XP 143, XP 243 or QP 341E with MTU. The cost of new totally less than 250k.
Electronics Forum | Thu Oct 04 00:01:59 EDT 2018 | gaintstar
Flason SMT FUJI Pick and Place Machine: http://www.flason-smt.com/product/FUJI-Chip-Mounter-SMT-spare-parts-A10395-Fiber-Amplifier.html http://www.flason-smt.com/product/FUJI-Chip-Mounter-SMT-spare-parts-Amplifier-A1038t.html http://www.flason-smt.co
Electronics Forum | Wed Jan 05 10:22:55 EST 2005 | Mike B
We're getting an error on our CP643 that we can't seem to make sense of. It's a D1 axis error, but we're only getting it when we run a feeder on device 140. Any advice would be appreciated.
Electronics Forum | Wed Apr 22 12:50:39 EDT 2020 | rodrigo
Hi all, One of our Fuji CP-642 machines has a weird problem. It does not happen every time but often enough that it is a problem. I power up and press start to zero it. The problem is the zero...ing does not finish. It moves the xy-table, D1/D2 table
Electronics Forum | Thu Apr 03 12:36:30 EDT 2014 | jimmyboz
Hold the F1 key during power up, it will boot into the I/O screen. Check the 3 photo zones. Check the door switch. In the main screen you can cancel D1 or D2, then you can swap light sensors. Check carefully the wiring, there is a SYNC wire betwee
Electronics Forum | Fri Dec 08 19:02:12 EST 2023 | madisreivik
Found the main problem During messing around (hopelessly :) we had found the calibration menu and pressed "check". Machine thought that there was a calibration nozzle (maybe 10x10mm square) but in reality, there was d=1.0mm nozzle. Machine decided
| 1 |
