Electronics Forum | Wed Sep 04 20:29:56 EDT 2013 | saibot
We had that problem a few months ago with one of ours. Had to replace both y-axis motors and the tech said it's a common problem with the Opal-XII.
Electronics Forum | Wed Sep 04 11:37:30 EDT 2013 | trice1212
Afternoon SMTnet forum users, The Assembleon Opal-XII we use has been showing an error when ran at 100% speed. We talked to the tech in AZ and he believes we have a problem with our y-motors. We turned the speed down and haven't had the problem com
Electronics Forum | Fri Feb 15 15:09:24 EST 2008 | soudomphong
Anybody have any idea where to get the cutter motor for siplace 80-S20 with reasonable price? I am also looking for S20 head board, and a Y-axis motor. Any help would be much appreciated, thank you.
Electronics Forum | Wed Aug 24 09:20:25 EDT 2016 | dekhead
Suspect comms link error from Y3 to Y1 crate. COM 2 off of CPU, depending on board. If CPU board has RS485 port it is direct to back panel of PC; if older board it only has RS232 and thus requires 232/485 converter board (internal to PC). then direct
Electronics Forum | Fri Dec 10 02:49:06 EST 2010 | bagindia
we are facing vision error problem after running the machine for half an hour.Cause is x-axis motor % is changing & also motion is little harder compared with Y-axis
Electronics Forum | Wed Oct 26 05:44:39 EDT 2022 | spacecase
Hello all, I was looking at a Samsung SM421-f component placing machine and it's throwing up an error that was not described in the troubleshooting guide. Anytime I try to move the camera or home it the machine stops and the screen says that a skew e
Electronics Forum | Fri Sep 11 12:44:16 EDT 2015 | simons
Our Philips Orion shows a L049 motor error immediately after we turn it on. Note that the Y axis servomotor was very hot prior to the last shutdown. Is this a problem with the motor or one of the boards?
Electronics Forum | Thu Nov 10 18:58:38 EST 2005 | darby
What is the problem Peter? See a recent posting on a Y axis problem with the same style of machine. If the encoder is cactus, buy a new motor. Sorry, this is the only solution I know of.
Electronics Forum | Fri Jul 07 17:17:43 EDT 2023 | ttheis
We swapped the Y1 and Y2 pc800 controllers with no change. We swapped out the UIMC III-I cards from another machine with no change. VRM amps all look OK, no errors. The machine moves the head both in the x and y directions during the zeroing attemp
Electronics Forum | Sat Jul 08 02:10:31 EDT 2023 | unsung
Wipe down and clean the 2 Gold strips on Y Axis and the encoder ( located on both sides of the machines covers must be removed ) Probably has dirt happen to someone who had an old universal 2007 that was sitting outside in the open air for a few day
