Electronics Forum | Tue Jun 19 17:42:38 EDT 2007 | dyoungquist
We run a TP9 machine and had a very similar problem with it. On a TP9 machine there is a power supply board where all the voltages are generated. It is located on the bottom side of the unit. The problen was with one of the fuse holders. The co
Electronics Forum | Fri Apr 21 23:13:59 EDT 2006 | valuems
The snema connecters are located behind the front cover, and to the left of the small power supply. The connecters are up side down. The front one is the left side and the second one back id the right side. Left is normaly the upstream and the rig
Electronics Forum | Wed Sep 07 07:53:16 EDT 2016 | ttheis
Looks like I've got to reconfigure the fmi connections. Only pins 1 & 2 populated and when I jump the fownline pins the upline ready signal is activated. I'll reference the diagram and setup the connections for smema.
Electronics Forum | Wed Aug 31 09:45:36 EDT 2016 | ttheis
I have a smema conveyor connected to the downline fmi connection on my up500 but the fmi sugnals show the coneyor ready signal going ro the upline ready input (screenshot). The downline ready output is activated qhen a board is output from the printe
Electronics Forum | Wed Sep 07 16:36:18 EDT 2016 | ttheis
It does look like it was setup for fuji or siemens connection. I did get the smema signals working; had to add the connections for pins 3 & 4 on both ports and move some of the existing connections according to the smema diagram. Also, I wasn't seein
Electronics Forum | Fri Apr 21 16:55:16 EDT 2006 | Geo E
I am trying to find out if the AP20 MPM Printer is SMEMA ready or was it an Add-on, I can not find any documentation in the manual as to where the Smema is to be connected.Or does the diagrams show any smema hook ups. Any help would be appreciated.
Electronics Forum | Sat Aug 11 05:29:31 EDT 2007 | johnz
We are having a problem with JST connector ICM-MA50H-SS52-1161 LF SN. After reflow oven soldering we have mostly problem with soldering quality for firs or last leg of the connector. (There is no connection- leg just lays-lift on the solder no wicki
Electronics Forum | Sun Nov 27 11:19:55 EST 2005 | cyber_wolf
Dude, Scope the big ribbon cables on either side of the X-axis for cracks. They usually break where the clamp holds them on the X wagon. Also, all of your X camera stuff goes through the XWB board.Try swapping it if you have another. I am not sure
Electronics Forum | Wed Aug 31 17:12:23 EDT 2016 | ttheis
Yeah, it's set to use SMEMA for down line. I have the conveyor conected to downline fmi on up500 (right side of machine,) but the Upline Ready light is activated on the up500 when the conveyor is ready and not the downline like I would expect to see.
Electronics Forum | Sat Nov 26 10:17:04 EST 2005 | BillyD
All: I'm having a rough time with one of my Mydata cameras. Specifically, the X-wagon camera. I've got no video from it, no light from it, etc. I've checked all the connections, all seems fine, but it does not work. Does anyone know where there
winsouce.jpg)
