Electronics Forum | Wed Apr 18 20:41:59 EDT 2007 | Machine Designer
The point is that shift is all about adapting not doom and gloom. BTW: Thanks for the flame and insulting words Brett. Way to hijack a thread that merely pointed to some interesting facts that could create some interesting dialog. I was merely inviti
Electronics Forum | Fri Apr 30 13:26:10 EDT 2021 | amaliahx
The pandemic has altered people's habits, causing a surge in demand for home electronic devices. This has swept the global chip supply and disrupted automobile manufacturing. The pandemic has led to the global shortage of semiconductors or chips, and
Electronics Forum | Mon Mar 06 13:00:37 EST 2006 | global
We have a Siplace S15 and I would like to know if it is possible to make it skip a part during the placement operation with out aborting the job? In section 5.4.4.4 of the user's manual it describes how to set a track to empty and proceed on with the
Electronics Forum | Fri Jan 02 22:57:28 EST 2004 | darburch
We are also curently considering Flexa and would like any real world info. 1: has anyone had experience with flexa with/without the Aegis software? 2: Are the graphics as easily editted as Fujicam? 3: Is it easier to set the access to menus/options t
Electronics Forum | Mon Aug 25 16:14:59 EDT 2014 | dman97
In Fuji flexa, under the machine configuration tab. Panel and Board mark reading order should be set to SKIP MARK. (this only works if you have the skip mark active in your fiducial list)If it is set to FIDUCIAL MARK, then the machine will ALWAYS pic
Electronics Forum | Tue Mar 20 19:18:53 EDT 2007 | diesel_1t
Hi to all, thank you very much for your feedback. The part is rotated before inspection; and also tend to be shifted to the same direction of pre-rotation so i think is not correcting misalignment or maybe some settings on shape data are not correc
Electronics Forum | Fri May 02 14:11:13 EDT 2014 | comandorobles176
We recived a used IP3 and don't have NG parts conveyor and I want to set the proper to discard component only in ng parts discard box.I think is in "Machine_ID" but I don't know how, we have Fuji Flexa sofware. any help?
Electronics Forum | Thu Mar 12 00:32:12 EDT 2015 | mdang
I am setting Fuji Flexa to communicate with CP8 machine. When I create a new machine, I has to fill out the following value Machine Communication Server: ? Get Production Data : (yes/no) GEM Host Name: ? Disable GEM : (Yes/no) TCP/IP Port #: ? I c
Electronics Forum | Tue Dec 06 19:44:10 EST 2011 | comando
Hello every one! I need help with a misaligned theta at plcc44, the machine is a IP3 smd3, firmware 2.99, vision card 4400 and both camera type YD2048N on label but in Proper data is set 2 (I don't know if this is right) we use Fuji flexa, Back Lig
Electronics Forum | Fri Mar 13 10:24:35 EDT 2015 | assuredtech
I am setting Fuji Flexa to communicate with CP8 > machine. When I create a new machine, I has to > fill out the following value Machine > Communication Server: ? Get Production Data : > (yes/no) GEM Host Name: ? Disable GEM : > (Yes/no) TCP/IP
A Manufacturer of High Quality, Precision, Automated Fluid Dispensing and Conformal Coating Systems, SMT Cover Tape Peel Tester and Lead Forming machines for through-hole component preparation.
611 Hollingsworth Street
Grand Junction, CO USA
Phone: (970) 245-0408
.png)
