Electronics Forum | Tue Sep 11 09:08:17 EDT 2007 | gemengr
Can not boot up . during down load vision system,an error come up VISION HARDWARE ERROR FAIL IN FUNCTION 1 STATE 2,VP STATE 0X28 ERR 0 any one know what's wrong with it.. thank you.
Electronics Forum | Thu May 23 12:27:19 EDT 2019 | weglimir
Hello I have problem with card: VPM-5238D - Namely when printer starts, and DEK program initializes, it hangs for a while on "Downloading vision system" and then following error appears: "Vision Hardware Error - FATAL ERROR - REINITALIZE MACHINE" "
Electronics Forum | Thu Sep 05 01:56:38 EDT 2013 | ciciswift
the Layers - > Add the Layers, or click the shortcut icon on the left toolbar, enter in the wake of a "Number of new the Layers" need to increase the Number of Layers. 2. Delete the layer: Edit - > the Layers - > Remove the Layers, and choose to dele
Electronics Forum | Fri Jan 27 16:50:22 EST 2006 | patrickbruneel
GS I am not a lawyer and the European directive has a lot of grey areas. But if you look at 1.2 in the link I send you it states that when an appliance can still function when the electrical current is off this type of equipment is not covered by di
Electronics Forum | Wed Nov 29 11:46:57 EST 2006 | slthomas
IPC 610 *C* states that the solder thickness requirement is a properly wetted termination is evident. Fillet height is another aspect and is usually specific to the package but is some function of solder thickness plus a percentage of lead height. D
Electronics Forum | Wed Jul 09 12:23:45 EDT 2014 | guts1872
We have cleaned the encoders even though they look pretty clean. The function clear doesnt have any effect on the machine while it is in this state. Have not checked the mag tracks but will give it a look.
Electronics Forum | Wed Mar 24 11:09:44 EDT 2010 | rajeshwara
Hello Sir I faced the same problem for QFP in DTH product in India. IPC stated that void should not be more than 25% of solder joint. But this type of void definatly create problem during functional test. Please check the folloeing point... 1.Check t
Electronics Forum | Tue Apr 19 05:42:13 EDT 2005 | woodglass
There's two sensors at the rear of the XY table. Make sure that these are functioning correctly. You can view their states in the I/O map. The solenoid which actuates the table base up/down air cylinder is also at the rear of the table, to the left o
Electronics Forum | Tue Sep 15 09:28:59 EDT 1998 | Clark Swainston
| Currently there are 2-3 questions on the admin page that are technical and are not getting the response they deserve. This is probably because the main stream of the SMTnetters don't check this part of the forum as often as they check the technica
Electronics Forum | Fri Nov 03 08:27:11 EST 2000 | CAL
1) You also may want to contact your OEM to see if there is interest in purchasing the equipment. You did not state the age or condition of your equipment but the OEM's are buying back machines and refurbishing them for resale. The long lead times OE
Golden State is a contract manufacturer that makes wire harnesses, electromechanical assemblies (box builds, subassemblies, PCBAs, kits, etc.) and services (sorting, rework, value additive manufacturing engineering)
18220 Butterfield Blvd
Morgan Hill, CA USA
Phone: 5102268155
