Electronics Forum | Tue Sep 13 07:00:28 EDT 2016 | awhite
Thanks for the reply. When you hit start on the printer, you can see it send the "start cycle (SMEMA)" signal, and it immediately goes to "awaiting board from upstream." This tells me that the printer knows a signal has definitely been sent and rece
Electronics Forum | Mon Sep 12 09:26:00 EDT 2016 | awhite
Our MPM Up2000 HIE is having a communication problem with any upstream machine we place in front of it...i.e. conveyor, board loader, etc. It all started when we removed a conveyor from inbetween it and a board loader, and hooked those machines up di
Electronics Forum | Tue Sep 13 10:00:27 EDT 2016 | awhite
Switched out the mech. relay on the board loader, no change. Same behavior. Could not find a mech. relay on the printer... SMEMA wiring appears go directly to a PCB. And it is at that point that I run out of talent. If the machine weren't dedicate
Electronics Forum | Tue Dec 07 00:53:48 EST 2004 | donb
I think I have schematics for a Fuji loader here. Let me know if you want me to scan & email or fax some pages.
Electronics Forum | Mon Nov 29 13:01:35 EST 2004 | bobsavenger
I have a DEK 265LT screen printer and a Fuji bare board loader. I cannot get the two machines to talk through the SMEMA cable. I have the personality card for the DEK and I have the correct cable for a FUJI machine. Is there something that I nee
Electronics Forum | Mon Dec 06 00:44:45 EST 2004 | donb
You probably have already done this... but you need to enter the maintenance program with the maintenance key, select "Set Prefs" scroll down to "Upline Machine" and enter "Fuji".
Electronics Forum | Mon Dec 06 21:41:13 EST 2004 | pdeuel
I have the same problem but an MPM downstream of the Fuji. Im looking for schematics for this Fuji. Before we had another machine hooked to this Fuji and the output switch needed to be set to latch. Otherwise only a pulse was seen and it was not long
| 1 |
