Electronics Forum | Tue Feb 09 14:32:04 EST 2021 | bobpan
You have to disable some lines in the machine.cfg file. If you do this....save the original before modifying it. I think you disable the gantry/head and the mei for Gantry 2.
Electronics Forum | Tue Feb 09 10:34:53 EST 2021 | jamesn
Hello Gents I have a problem with the head on gantry 2. I think it needs replacing but in the meantime Can anyone on the forum tell me how to disable it so the machine will initialise and run gantry 1 Ive been told it can be done but they cant rememb
Electronics Forum | Wed Jan 23 14:26:52 EST 2008 | operator
I have seen the bad alignment error many times and never had to replace the head for it. It usually has something to do with the laser windows being dirty or cracked. Also it could be your profile settings. Make sure all of these things are perfect b
Electronics Forum | Wed Jan 23 13:02:35 EST 2008 | tbkonrad
Thanks for the info. I called Mike Tieman earlier and he recommended I do the exact same things. He said that there should be very little resistance on the theta of the Z-rods, (not the case) so he recommended that the P4 head be replaced. Mike is
Electronics Forum | Wed Jan 23 11:28:47 EST 2008 | tbkonrad
Help! Since last Friday i have been having issues with a Quad qsv-1, it all started with a quad align error, i found there to be a small quantity of grease covering the lenses on both quad align sensors. I wiped the grease off and then everything s
Electronics Forum | Tue Feb 09 14:53:50 EST 2021 | jamesn
Thank you bobpan much appreciated I will give it a go Regards James
Electronics Forum | Wed Feb 10 19:29:45 EST 2021 | bobpan
I found a proper procedure to do this. Its rather long. Go to http://www.precision-repairs.com and email me and i will send it to you. Bob
Electronics Forum | Wed Jan 23 14:30:09 EST 2008 | operator
Additionally, I have seen the bad align error from incorrect pickup Z. Quad align can freak out sometimes if it sees something it doesn't like. If all else fails I just reboot and 99% of the time the problem goes away.
Electronics Forum | Mon Aug 04 12:34:06 EDT 2014 | cyber_wolf
Those of you that have Momentums may want to have a look at the metal cover that covers the X-camera ball screw. I would be very interested to know if the top of your camera bracket is rubbing on the bottom of the X-vision ball screw cover. Please
Electronics Forum | Wed Jan 23 12:35:24 EST 2008 | bobpan
Here is a few things to try.... 1. Spin the z-shaft with your fingers and make sure it is smooth and easy to turn. 2. Check your handling in your profile for the part that the software is locking up on.......You cannot go any slower than 40% or this
.gif)
