Electronics Forum | Mon May 02 12:28:03 EDT 2016 | adamjs
Why can't you place the entire job the same day you paste it? I can. But setting up and properly cleaning the stenciling machine takes 2-3 hours. We only run one shift. If we do that every day we're spending most the time on setup+teardown. Much
Electronics Forum | Mon May 02 12:35:33 EDT 2016 | adamjs
Or try : http://www.sipad.com/ I think sipad is incredibly cool and would be the perfect solution, but is way too expensive. We're paying $0.80/each for four-layer ENIG boards, 50cm^2 with 0.125mm trace/space and 0.8mm-pitch LGA landings in lots of
Electronics Forum | Thu Mar 06 14:35:09 EST 2025 | kumarb
Hi. Would anyone be able to offer advice on replacement gas springs for our Ekra X4 machine? The lid landing on my head was not a pleasant experience. If you have replaced these, have you used the OEM gas springs or 3rd party? Any reference part numb
Electronics Forum | Mon Jun 27 03:40:44 EDT 2011 | samsim
Other areas you can focus 1) Find out alternative chemical and solder materials for lower cost. 2) Set high power consumption machine (such as Oven and wave) to idle mode when not running to cut electrical consumption. 3) Reduce the used of N2 gas.
Electronics Forum | Wed Feb 08 22:05:54 EST 2017 | cromaclear
Hello to all, I am using ersa versaflow 3 selective soldering machine, i am having problems with nitrogen gas ring contamination. How can i clean this rings,what do you use? Ultrasonic bath maybe?
Electronics Forum | Fri Mar 29 20:07:50 EDT 2019 | sarason
I measured the temperature rise when I built the unit and it has a nice linear rise in temperature over the 3 minutes. I have used the Quikees before. The galcon gas stinks and must be evacuated. The galcon is expensive. The galcon is a perflourocar
Electronics Forum | Thu Aug 21 09:05:07 EDT 2003 | davef
Use a cartridge that's approved [conform to OSHA 42 CFR 84] to provide respiratory protection against organic vapors, chlorine, hydrogen chloride, sulfur dioxide, chlorine dioxide, and hydrogen fluoride with a P100 particulate filter which is effecti
Electronics Forum | Wed Aug 22 16:41:09 EDT 2018 | emeto
To all good suggestions I will add a few other thoughts: 1. Check PCB design(attached). THis mask clearance there is designed so you have some gas escape plan- verify if your PCB design follows that. 2. You can have a long soak reflow profile to re
Electronics Forum | Mon Mar 10 11:43:37 EDT 2025 | kumarb
Wish it was that simple. We have now sourced a replacement after hours of reviewing the details. Will confirm later today after attempting the replacement. For future readers, the original is from a German company and it is no longer on their websit
Electronics Forum | Thu Jun 30 18:28:47 EDT 2005 | KEN
1. Migrate to horse-shoe pad design. 2. Verify your furnace is level. 3. Verify your chains are not jerking around. 4. Speed control for fans / gas amplifiers are correct or normal? 5. (this happended to me once) Make sure you don't have any f
