Electronics Forum | Tue Feb 21 09:19:50 EST 2006 | Chunks
Hi Mark, Not to be condescending, but is your 265 camera in focus? I've seen one instance of this. If it�s not the camera, and you are sure all your other parameters are good, , then poor definition can be from bad snap-off or bad gasketing. Snap
Electronics Forum | Fri Dec 16 10:57:38 EST 2022 | sarason
In the automotive industry there has been a swing away from gaskets and a movement to high temp resistant sealing compounds. In all probability your original gasket would have been viton for high temp O-rings. So if that is the case the replacement
Electronics Forum | Mon Dec 19 21:34:47 EST 2022 | stephendo
To add to that we once had to replace the gaskets in a very old oven. We couldn't find any so we used a high temperature sealant. And then realized that they weren't gaskets originally, it was originally sealed with high temperature sealant. After it
Electronics Forum | Thu Mar 16 10:04:41 EST 2006 | slthomas
"better gasketing, less dog-earing" I suppose gasketing could contribute but my assumption is that it's a function of better shearing action between the blade edge and the aperture wall. You get a more consistent shape on the top of the paste deposi
Electronics Forum | Thu Jul 29 08:00:34 EDT 2010 | markhoch
Does anyone know of a good gasketing material that will hold up over time in a select coat fixture?
Electronics Forum | Wed Dec 14 17:18:41 EST 2022 | andersoma
Our RD-1 vapor phase is in need of new heater gaskets. Does anyone where these can be procured or what the material is?
Electronics Forum | Wed Sep 21 15:49:45 EDT 2022 | markhoch
I agree. The silkscreen will cause a gasketing issue with the stencil.
Electronics Forum | Mon May 01 22:55:02 EDT 2006 | KEN
....am I reading this correctly? "Screen Printing" or "Stencil Printing" Screen = agree = off-contact.....it's fuzzy going back into the memory banks to the early 90's. Screen mesh and emulsion will stretch to produce the gasket affect while snapp
Electronics Forum | Tue Nov 11 16:30:08 EST 2008 | naynayno
Occasionally solder mask thickness is believed to be the cause of gasketing challenges during paste printing. We currently specific IPC-SM-840 on our fab drawings but this provides no limits or guidelines on thickness. I do not want to cause an unr
Electronics Forum | Fri Oct 10 16:23:59 EDT 2014 | dilogic
First, plug all holes with nozzles or plugs. Then use I/O diagnostics to fire changer up and activate vacuum. Then try to remove each of the nozzles and see if the vacuumm holds. If it does, check vacuum detector switch (mounted on changer side). The
ORION provides innovative solutions to our customers' EMI/RFI Shielding, Insulating, Screening and Sealing needs in a broad spectrum of manufacturing environments.
Manufacturer / Distributor / Consultant / Service Provider
1 Orion Park Drive
Ayer, MA USA
Phone: 978-772-6000