Electronics Forum | Sat Mar 17 15:12:33 EST 2001 | robhal
First thing to check is that you have a good gasket between the PCB and the stencil (if not check that the tactile is free of paste at the base of it and calibrate the tactile. I am assuming it is not a head mounted tactile) Also check that the wipe
Electronics Forum | Thu Sep 24 19:54:40 EDT 1998 | S. Evers
| I am looking for anyone out there that has had experience with stenciling with chipbonder adhesives. I need information on material and stencil design. The firm who can help is K&J marketing their new KEPOCH stencil material is a (plastic) polyimi
Electronics Forum | Wed Sep 19 13:43:49 EDT 2001 | jschake
I cannot report having experience with 0201 printing applications on flex circuits. Generally, I would be concerned with handling of the flex substrate. A carefully designed vacuum capable custom tooling fixture would likely be required to ensure p
Electronics Forum | Fri Sep 21 14:45:36 EDT 2001 | jschake
I asked several people their opinion of HASL 0201 pads and there was no positive feedback whatsoever. The most common concern was the domed/convex shape of the pad finish that would result in aperture gasketing problems, which you may already have e
Electronics Forum | Wed Jan 08 14:36:44 EST 2003 | davef
It depends on your product requirements. We don't like to print off-pad, because: * Tough to control the amount of paste that squirts onto the board, because the aperture is not gasketed to the pad on the board. * Some paste that squirts between the
Electronics Forum | Wed Nov 05 17:36:12 EST 2003 | Stephen
Make sure that the side of the square is the diameter of the pad, That is that the circle is inside the square not that the square is inside the circle. normally the aperatures are smaller than the pad to get gasketing. In this case the idea is to
Electronics Forum | Tue Jul 27 11:34:05 EDT 2004 | C Lampron
Nippy, This is exactly what we are seeing. The exessive pads are all on one side of the board. This is a 10 up panel 5x2. All of the QFP's on one side on the panel are not releasing or are not gasketing and causing bridging. So the defects are rangi
Electronics Forum | Wed Feb 22 16:55:04 EST 2006 | mark
Hi, We are not using vaccum caps. The support pins for both printers is the same ande cover all board (components only on Top side of the PCB). I will check snap-off (right know setting 0.2-04. mm/s). I also suspected poor gasketing but clamps are o
Electronics Forum | Thu Jun 15 09:58:12 EDT 2006 | slthomas
Just to add to what dave said, the only limitation to how frequently you clean is the cost of the cleaning medium. You can wipe every board if you want to, but you'll go through material accordingly. If you're printing 16mil pitch or smaller, cleani
Electronics Forum | Thu Dec 28 22:58:30 EST 2006 | davef
If this is same TennRich Type B [ http://www.tennrich.com/trtw/TR_PI_Prod_Info.php?pid=2 ] that is an EMI gasket, it needs to be glued with a conductive adhesive. It has the same thermal capability as a Snickers Bar, about 90*C top end.
ORION provides innovative solutions to our customers' EMI/RFI Shielding, Insulating, Screening and Sealing needs in a broad spectrum of manufacturing environments.
Manufacturer / Distributor / Consultant / Service Provider
1 Orion Park Drive
Ayer, MA USA
Phone: 978-772-6000
