Electronics Forum | Tue Sep 13 19:06:49 EDT 2016 | dontfeedphils
Well I've tried to get in touch with Ovation for weeks now without luck, so maybe someone here will have the answers I'm looking for. One of our Grid-Lok Gold modules is leaking air from the sides (it pushes the pins up fine, but when air is applied
Electronics Forum | Tue Mar 06 13:39:49 EST 2018 | GTune
Hello everyone, I am having trouble with our UIC VCD through-hole pick and place machines. It has been sitting around for several years now and I had to replace half the gaskets in the machine which werecausing slow movement. I'm getting an error mes
Electronics Forum | Thu Mar 28 15:53:49 EDT 2019 | SMTA-Jon
As a CM, we don’t have a lot of input on the PCB layouts we receive. Some engineers/software packages output the paste layer 1 to 1, some do an across the board reduction, and some set each part up individually with different reductions per footprin
Electronics Forum | Wed Sep 04 13:32:22 EDT 2019 | bobpan
Try these things: 1. Do a function 30....your nozzle height should consistently be around 200 +/-20....but whatever number it does find it shouldn't change. (with nozzle on) 2. Most times its the z-bellows....an old z bellows that has a worn out spri
Electronics Forum | Thu May 20 22:38:01 EDT 2021 | kumarb
For closure to all readers of this thread...many thanks to Michal for this support. Trans-tec (USA) was great in replying to our countless emails on this topic. We sourced a replacement solenoid # A041E1-48W for our Emerald-X = YV88X. The part was a
Electronics Forum | Fri May 19 11:20:12 EDT 2000 | John Thorup
Dave - well said ScottM - I'm appalled - Your management sounds like a throwback to an early industrial age where the workers were treated as a commodity. It's not right to do only what you're forced to do when protecting human beings and the enviro
Electronics Forum | Thu Jun 17 21:24:32 EDT 1999 | Dean
| first of all what is the technical term for the small amount of solder on a plated pad. we are getting poor screen printing gasketing on a 20 mil qfp due to this solder not being even or too high in spots and not covering the length of the pads. an
Electronics Forum | Mon May 24 13:33:46 EDT 1999 | Dave F
| We are running a number of boards with 8-10 25 mil PQFPs on board. Our process is mature with at least 3 years experiance and statistically few opens on the QFPs. Our beloved purchasing department has chased the almighty $ and changed FAB vendor
Electronics Forum | Thu Dec 14 12:18:01 EST 2000 | genny
Hello all, Our company has always used HASL finish on our products. Recently however, we have a had a problem on a couple of boards that I have been told cannot be avoided with HASL, and we should switch to ENIG(electroless nickel immersion gold).
Electronics Forum | Mon Aug 07 10:22:13 EDT 2000 | genglish
Ramon, I have had experience in the problems you are witnessing. The problem can relate to a number of factors. Obviously the printing process is the first place to start your investigations, try looking at the stencil apertures for bleed under the
ORION provides innovative solutions to our customers' EMI/RFI Shielding, Insulating, Screening and Sealing needs in a broad spectrum of manufacturing environments.
Manufacturer / Distributor / Consultant / Service Provider
1 Orion Park Drive
Ayer, MA USA
Phone: 978-772-6000
.gif)
