Electronics Forum | Thu Aug 16 14:02:08 EDT 2012 | benreben
Hi all, i search the proper method for adjusting gain/offset on fuji FCP4 can you help me? thx
Electronics Forum | Sat Aug 18 10:06:05 EDT 2012 | cyber_wolf
There is no defined method that I am aware of. If your bulbs are old replace them. Other than that adjust the gain and offset until there is clear definition on the edges of the components. Keep an eye on the dump box.If the dump box stays relatively
Electronics Forum | Tue Feb 07 11:41:36 EST 2006 | PWH
Band Aide Quick Fix to get you running - Change x-value for all global fiducials in your program the exact same amount as the x-offset you are experiencing on your bad machine. Likely, if (0,0) is front-left, you should move all global fids 0.3mm th
Electronics Forum | Mon Jan 30 01:34:28 EST 2006 | ____
Export CCIMF files for both scenario's and have Fuji America look to see if there is an actual programming offset problem. To be exactly .3mm off seems a little odd.
Electronics Forum | Thu May 13 10:43:34 EDT 2004 | rob_thomas
hi, i have a question relating to fiducial, is > the fiducial normally comes with the pick and > place data from the custommer or we have to > define it by ourself? how to set its coordinate > so that the cp6 and ip3 (using Fujicam software) > w
Electronics Forum | Wed Jan 23 22:30:46 EST 2002 | Jones
The CP-65E handles a wide range of board sizes, including large boards up to 508 x 457 mm or 20 x 18 inches. Handling consumer as well as industrial applications, this durable and highly efficient machine achieves a cycle time of 0.12 seconds/shot an
Electronics Forum | Mon Jan 17 15:34:38 EST 2005 | montec2000
Just a thought, but check to make sure you dont have a pickup offset in your pd or machine thats causeing your problem.
Electronics Forum | Wed Dec 23 22:00:50 EST 1998 | Phillip Hunter
| Many machines now have adaptive pick that helps tune in the pickup as the 0402 part moves around in the pocket. Fuji may have a feature like this, but I think they adapt the pickup in only one axis (by adjusting the feeder rack). Unfortunately th
Electronics Forum | Fri Jun 22 11:02:13 EDT 2007 | gregf912
I have a CP642E machine that will not function if auto adjust is enabled in Part Descriptor. Symptom: Auto pick offset causes machine to pick part off center to the point of going to end of part after several picks. This only happens to parts that ha
Electronics Forum | Mon Oct 03 12:17:18 EDT 2005 | jdengler
Another problem I have seen on CP's is mixing suppliers on the Anti-Marking Illumination Disks. Some after market suppliers disks do not reflect the light the same as Fuji's disks. It is nearly impossible to get the lighting level good enough for r
A Manufacturer of High Quality, Precision, Automated Fluid Dispensing and Conformal Coating Systems, SMT Cover Tape Peel Tester and Lead Forming machines for through-hole component preparation.
611 Hollingsworth Street
Grand Junction, CO USA
Phone: (970) 245-0408
