Electronics Forum | Mon Nov 14 08:19:19 EST 2005 | cguerrero
Has anyone had issues with their glue stations. After our software upgrades it seems to not be working properly. We have had it slam into the pot, not go into the pot, slam the arm, etc.. Default glue dots used to work now I have to set all their bi
Electronics Forum | Thu Nov 17 13:51:27 EST 2005 | mnguyen
Never could get that thing to work rite. Better off getting a glue stencil or a manual dispenser. Even if you do get it to work it is difficult to control the glue dot size to stay stable either you get too much or not enough.
Electronics Forum | Tue Nov 21 13:45:07 EST 2006 | fujillews
Asymtech glue machine would do the job..different heads are available. Fuji GL series machines are also good but require a offline controller Even with PTH components Screen printing glue is still possible,some call it pump printing? what type of pl
Electronics Forum | Tue Dec 19 03:32:11 EST 2006 | ungun
Is there any method or machine that i can use to check glue size. I need to check 90% of the bottom side pcb area that have 200 glue point within 15 to 30 sec.
Electronics Forum | Wed Dec 20 04:08:09 EST 2006 | ungun
Sorry for the late reply. I use glue dispenser machine juki kd-775. It have dispensing diameter confirmation unit, but dispensing test tape can be hold for 2 to 3 days a roll if the output 300 pcs pcb with average glue point 100 per peace. Beside, i
Electronics Forum | Tue Mar 07 21:19:50 EST 2000 | Van Hoang Dinh
I have few problems below, 1.I had problem with clean glue stencil at the midle of the process and after the process. 2.Very hard to Fix the bridging on the (close pin) connectors through the wave. Anyone can help on this. Thanks Van
Electronics Forum | Tue Mar 07 21:19:50 EST 2000 | Van Hoang Dinh
I have few problems below, 1.I had problem with clean glue stencil at the midle of the process and after the process. 2.Very hard to Fix the bridging on the (close pin) connectors through the wave. Anyone can help on this. Thanks Van
Electronics Forum | Tue Feb 08 12:36:28 EST 2000 | Charlie
I'm looking for information from both those who do cure glue and reflow past with the same profile and those who have tried and decided against it. What were the problem? What are the limitations?
Electronics Forum | Fri Mar 10 13:50:42 EST 2006 | Frank
Contact your local Juki distributor. But as a reseller of used equipment they may not be too willing to help out. And why would you want to add the expense and hassle of adding a glue head on a machine?
Electronics Forum | Sun Mar 12 12:29:26 EST 2006 | Edward P. Woldendorp
Frank, Thank you for your reply. A customer in Russia asked us for this glue head. He runs a PM-570L machine. What would you advise him? Thank you and best regards, Edward