Electronics Forum | Mon Mar 07 11:20:10 EST 2005 | mrduckmann2000
Russ, I tried to get a screen for glue but the design engineer who laid this board out made up his own rules. The 0402 pads are to close for a proper dot size.....per the stencil house. That is why I am going the solder mask route. I would rather
Electronics Forum | Fri May 26 05:54:40 EDT 2000 | Sal
For the past year now we have been printing adhesive with no real problems. Our printing ranges from 0603's to SOIC using a variation of aperture sizes and metal thickness foils. The crucial parameters are : aperture sizes : These obviously depend o
Electronics Forum | Mon Dec 22 11:09:21 EST 2008 | mfcat
We changed paste manufacturers rather recently and are now seeing SOT23s falling off after wave solder. These parts have a dual process... we stencil print paste, apply glue, populate then reflow. Only SOT23s fall off, chips are fine. We do not be
Electronics Forum | Sun Mar 06 20:08:38 EST 2005 | mrduckmann2000
Davef, You have a good question. If we had perfect design engineers out there that would use the proper component spacing and not put SMT parts between and around thru-hole parts - glue and wave would work perfectly. I have done this with great su
Electronics Forum | Fri Mar 04 17:19:31 EST 2005 | davef
Mrduckmann2000: Why do you want to do this? * Removing a non-washable / peelable temporary solder resist [TSR] is going become very tedious, because they do not release well from small / tight / isolated features. * Clay from washable resists will
Electronics Forum | Wed Mar 08 09:32:57 EST 2000 | Dane Stokes
We use loctite to print with before begining testing on printing we asked loctite for the best cleaning solvent for there product. loctite had there own solvent that was designed to break down the propertys of their glue mix. Contact glue supplier an
Electronics Forum | Wed Mar 08 09:32:57 EST 2000 | Dane Stokes
We use loctite to print with before begining testing on printing we asked loctite for the best cleaning solvent for there product. loctite had there own solvent that was designed to break down the propertys of their glue mix. Contact glue supplier an
Electronics Forum | Sat Feb 12 10:33:31 EST 2000 | Francois Racine
First I'm a french people so excuse my bad english writing. I have a complete smt production line. First a screen printer DEK 240, a chip shooter PANASERT MVIIV, a multifonction machine MULTITRONIKS EP6000, a reflow oven at the end of the SMT line a
Electronics Forum | Sat Aug 07 11:10:03 EDT 1999 | JohnW
| Could someone give recommendation on the stencil opening for printing epoxy on HAL FR4 PCB for 0805 and 0603 size chips capacitors and resisitors. | My regular stencil manufacturer recommend the following: | Thickness: 8 mils | 0805 opening: Oblong
Electronics Forum | Mon Feb 22 12:04:15 EST 1999 | Dave F
| Please could you suggest a recommended aperture sizes for | printing of smd adhesives. Any recommendations on stencil thickness as well as stencil finish will be appreciated. | Mark: About the only rule of printing adhesives is: Keep it off the
