Electronics Forum | Fri Aug 19 05:20:40 EDT 2011 | kemasta
Hi! I am searching for a glue type which use for security purpose. The glue must not able to rework after full cure and fast curing time (within 5~10minutes). I have some sample in hand, but it seem quite expensive considering the volume that I am
Electronics Forum | Mon May 11 12:50:55 EDT 2009 | stepheniii
What is the purpose of glueing it? If it is glue the bottom side parts followed by reflowing the top side parts followed by wave soldering the bottom side parts, then it's easy to measure. Hold the board with the 0603s facing down. If they don't f
Electronics Forum | Tue Nov 06 19:41:42 EST 2001 | mparker
I say "wank 'em down 'till they break, then next time don't wank 'em so hard"! If all else fails, use lotsa Loktite or super glue!!! the preceding advice has been presented for amusement purposes only and is not the opinion of management.
Electronics Forum | Thu Aug 24 23:20:22 EDT 2017 | micropak
We often do double sided SMT assembly, never had issues with smaller components. However, we apply glue to heavier components like inductors, SD card sockets etc. For this purpose, we have a glue dispensing machine inline after the solder paste prin
Electronics Forum | Mon May 14 04:00:15 EDT 2018 | sarah2018
Before you buy glue dispensing machine, you need tell the supplier two question as below: Two questions before purchase 1.What’s type of glue do you use ? What’s the base characteristic ? A)One-component or two-component (A&B glue)； B)What is the A
Electronics Forum | Thu Mar 27 16:40:45 EDT 2008 | slthomas
(or just some static-safe foam tape) I need to seal a wire terminal block to a board for conformal coating purposes. Currently we glue it to a shim and glue the shim to the board (yuck), but I want to use die cut gaskets if I can make it cost effec
Electronics Forum | Wed Dec 06 22:35:05 EST 2006 | davef
Questions are: * When you say, "corner of some board's BGA chips", is it on the top of the package or between the board and the bottom of the package? * If between the board and the bottom of the package, does it span the distance between the board a
Electronics Forum | Mon Apr 23 11:49:46 EDT 2007 | ck_the_flip
Wow, you're using the Surface Mount Adhesive for mechanical vibration? I've never heard of SMT adhesive being used for things other than holding the components in place before wave solder. Does it work for mechanical purposes? Glue/Wave is a proce
Electronics Forum | Thu Sep 20 20:15:55 EDT 2001 | davef
We use glue for all kinds of purposes. [See, first we glue the lock on the office door. Then, we glue dadour locks on dakah. Next, we glue the ignition of the Benz. Now, webee gon stylin�, uh huh!] Oooops, sorry got lost there for a minute, the
Electronics Forum | Thu Aug 05 10:38:49 EDT 2004 | iggyslab
Is there a specific epoxy that is most suitable for sealing a polycarbonate chamber, which will have hydrogen flowing through it at no greater than 10psi? Can any epoxy that provides a watertight seal be used for hydrogen applications? We have th
.gif)
