Electronics Forum | Wed May 31 13:23:48 EDT 2006 | slthomas
You don't say anything about the appearance of the solder joints themselves. That would go a long ways towards identifying and possibly resolving your issues. Heating and cooling could affect performance if you have a/some cracked or otherwise loose
Electronics Forum | Thu Jun 01 09:46:36 EDT 2006 | slthomas
Our MOLE was the same way. Setting it on the floor was the best way to cool it down. I'm not sure you're ever going to do much better than a factory shielding box unless you just build a bigger one and put the whole thing in it...profiler and facto
Electronics Forum | Thu Jun 01 10:08:59 EDT 2006 | ratsalad
I sewed a sock out of a Nomex/Kevlar blend fabric because we had the same problem with our profiler. It works great. After one run through the reflow oven, the internal temp rises by about 5 degrees C. It used to go up by about 20-25 C. I can pic
Electronics Forum | Fri Jun 02 03:41:04 EDT 2006 | geb
Found the aramid fabric (Kevlar) on the website you suggested. Which thickness Aramid-and-Fiberglass Sheeting should I get, do I need to buy a strip as well to protect up to 600F? I was going to use PTFE-Coated Fiberglass Thread as it is rated up to
Electronics Forum | Fri Jun 23 09:02:17 EDT 2006 | paulinct
Glad to hear it is running good for you. I have my new wave solder machine in house.(hooking it up next week). I am debating between Sn100 and Cobalt 995 (metallic resources). Does anybody have an experience with the Cobalt. Or a reason not to go wit
Electronics Forum | Mon Jun 26 17:16:38 EDT 2006 | jbrower
Look here you dime store cowboy. Why in the heck would I ever contact you. You've done nothing, nor have you even proven that you are legit. Stop wasting bits on this forumn and either pony up with some useful information or go away. Jay
Electronics Forum | Wed Jun 14 11:55:34 EDT 2006 | Rob
What rpm is the Delta wave going at? (I think it was recommended to have it running at 700-800 rpm even if you are not using it, otherwise you get a dip in the main wave) At least that's what I think I remember from a trip to their factory, but they
Electronics Forum | Fri Jun 16 10:23:40 EDT 2006 | pms
Thanks Davef, We recommend ENIG to our customers at this time, we have not had any customers reporting issues with it so far. I like the protection of the nickle from copper dissolution during wave in a PB free scenerio, but the "Black-Pad" issue i
Electronics Forum | Fri Jun 16 16:14:19 EDT 2006 | jbrower
Hi Grant, I can't speak for reliability, I don't know how your boards are going to be used or what alloys you are using. As for RoHS compliancy as far as I understand the cut off if July 1. So any boards sold before that in the EU are OK. Best regard
Electronics Forum | Tue Jun 20 16:08:12 EDT 2006 | two cents
Here we go again........please do your Company and yourself a favor by listening to advice from someone other than the self proclaimed guru. Did'nt Ford think out of the box when the Edsel was designed? Good luck and make sure to check out all the al
