Electronics Forum | Thu Oct 28 18:14:51 EDT 1999 | John Thorup
Try looking for paste contamination somewhere. Dirty stencil, printer table or fixtures. Placement table/fixtures. Reflow belt/conveyer. Reuseable finger covers, if used. Try covering the fingers with Kapton tape during different stages of the proc
Electronics Forum | Mon May 18 17:59:06 EDT 1998 | Richard Jackson
I've tried every thing I can think of. Do you have any Ideas? What I have is micro balls on the gold fingers of panelize boards. These balls only appear on the gold finger. Or at least I can only find them on the gold fingers. What I have tried so
Electronics Forum | Sun Jan 23 03:23:09 EST 2000 | Rob Steltman
Hi We use a U-channel piece of high temperature silicon which is just pushed over the gold tabs before the soldering process. The silicon can be used over and over again. The advantages are that there is no mask on the board during the SMT process a
Electronics Forum | Tue Jul 01 17:38:24 EDT 2003 | jartman
I've faced this several times in the past, and the only real solution is to wirebond before SMT assembly. Everything leaves a residue, and trying to clean a residue off later is basically hopeless. This may require some trickery in your SMT process
Electronics Forum | Mon May 18 21:29:38 EDT 1998 | D.Lange
| I've tried every thing I can think of. Do you have any | Ideas? | What I have is micro balls on the gold fingers of | panelize boards. These balls only appear on the gold | finger. Or at least I can only find them on the gold | fingers. | What I
Electronics Forum | Tue May 19 12:29:59 EDT 1998 | Richard Jackson
| Richard, | You may be encountering solder paste contamination | on the assembly during the printing process. Solder | will reflow on tin/lead plated lands therefore invisible. | If you are washing the assembly prior to inspection | then you are
Electronics Forum | Tue Jan 26 19:43:02 EST 1999 | Ross Berntson
| hi, | i am working towards developing a no-clean process for a customer at contract manufacturing facility. the assemblies have gold fingers on them. these are masked to prevent from any damage to them during reflow soldering. the earlier proces
Electronics Forum | Tue Jan 26 19:43:26 EST 1999 | Ross Berntson
| hi, | i am working towards developing a no-clean process for a customer at contract manufacturing facility. the assemblies have gold fingers on them. these are masked to prevent from any damage to them during reflow soldering. the earlier proces
Electronics Forum | Tue May 19 12:54:55 EDT 1998 | Richard Jackson
| We had a similar problem. But whenever the solder came from the screen printer the solder would wet to the gold fingers, with the help of residual flux. But the problem is balls, that I assume are not wetted to the gold fingers but instead are jus
Electronics Forum | Tue May 19 10:23:06 EDT 1998 | Mike C
| Howdy Richard, | Welcome to the club! I now dub thee a full fledged member of the "Spotty Gold Finger and Bleeding Ulcer Society"...or SGFBUS for short... (GRIN) | I know it's not funny to be in that position, but there's so many different places t
