Electronics Forum | Wed Aug 06 20:50:42 EDT 2003 | davef
Well, if it "keeps coming up", let's take a pass at keeping down. For: * Requirement that gold be removed from components, pads, etc. is J-STD-001C, 5.4.1 * Context of that requirement [J-STD-001C, 5.4.1] and 6 or 7 references are in IPC-HDBK-001.
Electronics Forum | Fri Apr 13 21:02:19 EDT 2007 | Sam
Anyone experience using SnPb wire to gold plated ICs? I have tried to solder the SnPb wire to the gold plated ICs lead, but the surface finishing is dull. Can anyone explain that to me? Why it is not shinny surface? Any recommendation?
Electronics Forum | Mon Nov 09 06:28:03 EST 2015 | recard
Hi guys, we have a problem and I hope something can give nme some new information. We have big solderability problems with a gold plated board. We changed the paste already, but there is no improvement. Could the Vapor phase Technology cause the p
Electronics Forum | Wed Nov 11 13:51:19 EST 2015 | duchoang
Could you give us more details. Picture, profile, solder paste ...?
Electronics Forum | Thu Nov 12 11:21:42 EST 2015 | davef
IPC J-STD-003. Solderability Tests for Printed Boards
Electronics Forum | Mon Apr 25 21:52:58 EDT 2005 | KEN
I wonder if yor customer means wrong "flux"? Your not solderng to gold. Your soldering to Nickle. The gold is disolved and dispersed. Your joint strength comes from the SnNi intermetalic.
Electronics Forum | Sat Apr 23 19:31:25 EDT 2005 | molosse21
Hi, Is there a solder paste alloy espacially done to solder components on a pcb gold plated ??? I am using the AIM 297DX SN63/PB37 no clean and i had a comments from my customer telling me that i am not using the right alloy. Personally i never he
Electronics Forum | Wed Feb 03 23:40:26 EST 1999 | Chris G.
| Does anyone know if I will have problems soldering surface mount components to an all hard gold plated PC board. We want to use hard gold similar to gold used for edge fingers because our customer is concerned about wear and conductivity of connect
Electronics Forum | Fri Aug 22 09:49:31 EDT 2003 | davef
Ask your supplier for a corrective active and failure analysis of the boards. In parallel, send the boards to a failure analysis laboratory to determine the material on your gold pads. Take your work to another supplier.
Electronics Forum | Wed Feb 03 16:45:20 EST 1999 | Mark Henebry
Does anyone know if I will have problems soldering surface mount components to an all hard gold plated PC board. We want to use hard gold similar to gold used for edge fingers because our customer is concerned about wear and conductivity of connector