Electronics Forum | Tue Oct 07 08:38:05 EDT 2003 | davef
J-STD-001C requires removal of gold from (through-hole) component leads when the thickness of the gold layer is above 2.5 microns to prevent problems with embrittlement. The thickness of gold on an ENIG board typically is around 0.05 micron, resultin
Electronics Forum | Mon Jul 06 13:17:50 EDT 1998 | Upinder Singh
| | Hi all . | | Thanks to Ryan, Brian , Justin and Dave for the timely help earlier. | | I would appreciate if somebody could help me in the stated issue: | | I am trying to to place one thru hole 20 pin connector along with the SMT components by p
Electronics Forum | Tue Jun 30 18:37:19 EDT 1998 | Earl Moon
| Hi all . | Thanks to Ryan, Brian , Justin and Dave for the timely help earlier. | I would appreciate if somebody could help me in the stated issue: | I am trying to to place one thru hole 20 pin connector along with the SMT components by paste pri
Electronics Forum | Fri Dec 12 01:06:02 EST 2003 | kenny
Dear folks; I am currently looking a PCB manufacturer who can fabricate PCB with the following specification:- Board sizes: _20000__ x _20000__ mils Thickness: 125 mils PCB material: FR4 Surface finish: 30 microinches Gold over 200 micro inches Nic
Electronics Forum | Sun Aug 08 20:59:55 EDT 1999 | Dreamsniper
| | | What oven temperature should be used to reflow solder (Sn63Pb37) on a PC board (0.075" to 0.100" thickness) in 5 to 10 minutes? | | | | Profiling - tedious but important. As said, start with the paste manufacturers recomendation which is usua
Electronics Forum | Tue May 21 13:17:47 EDT 2019 | SMTA-Thomas
2.54 μm [100 μin] gold thickness and all through-hole leads that will be hand soldered regardless of gold thickness” (we automatically solder wash all components which violate this requirement). In all cases we have attempted different no clean flux
Electronics Forum | Sat Apr 11 14:31:16 EDT 1998 | Gary Simbulan
| | I would like to invite everyone to share/discuss | | information/knowledge/experience they have with | | the req's that are assumed to be valid for the | | temperature/time relation in the process of reflow | | soldering Pin In Paste, Intrusive R
Electronics Forum | Wed Sep 30 10:38:42 EDT 1998 | Earl Moon
| Anyone have ideas how to get MIL 50884 Qualification?. | | We are a small/mid sized Flex, rigid-flex circuit shop in Canada considering MIL Qualification. Is there any web site that we could check out? | | any advice is appreciated. | thank
Electronics Forum | Fri Sep 16 13:19:59 EDT 2005 | vinod
Friends, I have a PCB with Immersion GOld (ENIG) finish. Here are the detalis on the PCB. 1. 6 Layers 2. Immersion Gold (ENIG)Nickel 125-250 Micro inch. 3. FR4 Material 4. Thickness 0.062". I am having problem soldering the through hole components.
Electronics Forum | Fri Sep 16 11:58:46 EDT 2005 | vinod
Friends, I have a PCB with Immersion GOld (ENIG) finish. Here are the detalis on the PCB. 1. 6 Layers 2. Immersion Gold (ENIG)Nickel 125-250 Micro inch. 3. FR4 Material 4. Thickness 0.062". I am having problem soldering the through hole components.
.gif)
winsouce.jpg)