Electronics Forum | Fri Sep 21 16:57:47 EDT 2007 | chrisgriffin
Harry is right. Too much moisture in the air lines screws up the air cards. These pro-heads are somewhat of a pain to calibrate. I think it is a little pre-mature to say you probably need pneumatic cards. You just need to calibrate the pro-head.
Electronics Forum | Mon Oct 01 10:35:52 EDT 2007 | adlsmt
DBA tried to re-write thier software at least twice and failed. They ended up buying/partnering with EZ-Jobz from I think Austrailia. The new product and the old product are not the same at all in any way. Manex was originally based on FoxPro. We are
Electronics Forum | Tue Oct 16 18:07:53 EDT 2007 | jmelson
Oh, wait a minute. I have the complete control box from a CSM 66 III machine, Philips type 1306/40. That's the first one with the AC servo motors. The older ones had a stack of boards connected with masses of cables, the 1306/40 and later had a ba
Electronics Forum | Wed Oct 17 12:56:18 EDT 2007 | jmelson
The outboard I/O card is similar on both versions. But, that's where the similarity ends. The III machines (1306/40 and above) have a row of vertical boards that plug into a backplane on the bottom of the box. The 1306/20 and earlier have the boar
Electronics Forum | Wed Oct 10 11:20:31 EDT 2007 | jdengler
Do all 0201's reject at the same rate? If even 1 P/N has a lower reject rate this can point towards a feeder problem. I have had a similar problem on a CP-IV-2 with 0402's that was caused by feeders. If all reject at the same rate it can be the PD o
Electronics Forum | Fri Oct 12 15:31:28 EDT 2007 | wayne123
I am needing to know if anybody uses a Reflow oven Chain oil that doesn't create a horrible smell. Whenever we put this oil on it burns off and smells like I am stuck at a stop light behind a car with bad rings. I have looked at several oils that adv
Electronics Forum | Wed Oct 17 21:33:16 EDT 2007 | davef
What service company do you use for the sharpening of dykes, side cutters, diagonal cutters? What process controls do you suggest in maintaining good process from such a service company? While we're on the topic, we have aways used semi-flush cutte
Electronics Forum | Mon Oct 22 05:04:08 EDT 2007 | jkhiew
Hi, Recently we have encountered solder wicking on components termination (total of 13 pcs of components on one pcb)with Ag/Pd finishes during lead-free reflow soldering. The pcb is LF HASL surface finish and LF solder paste composition is SAC305.We
Electronics Forum | Wed Oct 31 12:06:08 EDT 2007 | devgru
We have the yestech systems and are very pleased with them. I would also suggest that you bring units into your facility to see a demonstration. It seems that there are really only two choices when it comes to the quick to program and easy to use ver
Electronics Forum | Wed Oct 24 11:10:55 EDT 2007 | dyoungquist
We are running an upgraded, refurbished MyData TP9 machine in our high mix, low volume production. With those improvements it does okay on the 0402s. The TP platform is no longer in production but they are still providing good support for machines
