Electronics Forum | Fri May 14 12:40:03 EDT 2004 | Kuru
My switch is good, I can check the switch and the two photo sensors on the input test screen. They are turning on and off.I can see it no the board too. When I start up I can see Tactile unit come down so I know pneumatics portion is good. I am still
Electronics Forum | Sat Sep 17 14:01:43 EDT 2005 | johnw
Hi all contact the guys at ALTUS GROUP these guys are all experts on mpm printers they are all x MPM service engineers they hold a vast stock of spares also I use these guys all the time and are good to deal with WWW.ALTUSGROUP.BIZ
Electronics Forum | Tue Sep 20 04:14:08 EDT 2005 | Rob
Yes, and you ruined all that good work by sending us Billy Ray Cyrus. (Don't think we aren't greatful that we're wearing levi's instead of lederhosen - it's never particularly warm over here!)
Electronics Forum | Fri Feb 06 15:52:18 EST 2004 | pjc
SPM is superior in terms of technology and application. SPM has larger print area, up to 20� x 19", vs. 17.7� x 15.7� for the MicroFlex. MicroFlex is microprocessor controlled while the SPM has a PC. SPM can print down to 12mil (0.3mm) fine pitch no
Electronics Forum | Thu Apr 15 16:13:13 EDT 2004 | pjc
Best recommendation is to compare the two machines with your boards and stencils. Either vendor should be able to arrange for a �test drive� at one of their demonstration facilities or at a local friendly customer. I�m afraid that your request for �o
Electronics Forum | Thu Apr 29 10:49:05 EDT 2004 | pjc
Yes, using an illuminated magnifing glass helps. How well your board fixuring is on the table will effect print alignment on other boards loaded. 0.5mm & 0.4mm will require very good fixuring, like you can get with tooling pins if the board has non-p
Electronics Forum | Thu May 13 23:01:07 EDT 2004 | fastek
Unplug the tactile sensor and check the switch with an ohm meter. If the tactile sensor switch is good go in one of the drawers in the back of the machine and with the help of your schematics find the opto-module that controls the tactile sensor circ
Electronics Forum | Tue Apr 20 10:37:27 EDT 2004 | rob_thomas
Debi, Both machines are good and will do a great job for you on Rigid as well flex circuits.Every Mfr.will come to your site and give you a piece of equipment on loan to try for a month hoping you'll buy from them.Why don't you arrange that little ex
Electronics Forum | Mon Apr 26 15:04:14 EDT 2004 | pjc
You are correct in understanding that the vision system comes into play for subsequent boards- to align them. Yes- if you missalign the first board and set the cameras to that board, all subsequet boards will not be aligned. Mylar is a thin polyester
Electronics Forum | Wed Aug 18 21:10:23 EDT 1999 | se
| | | Hi, | | | I'd like to ask some tips about the merits and shortcomings o | | | of both screen printer and stencil printer. For small quantity and highly mixed usage, which type of printer is suitable to our | | | application? | | | The board
winsouce.jpg)