Electronics Forum | Wed Dec 19 16:05:10 EST 2018 | ldavis
I created a spray fluxer for our wave solder years ago that is still working well although does consume a lot of flux and is also rather messy. It's cheap and easy though so what the heck, right? I just machined a manifold that will hold four BETE
Electronics Forum | Tue Nov 22 09:38:12 EST 2011 | daxman
Good morning everyone, We're whipping our maintenance into shape. For starters, we've acquired the proper lubricants for our Fuji machines. Most of the lubricants (AFC, LRL-3, Daphne EP2) come in accordion/bellows style grease tubes. This isn't a p
Electronics Forum | Wed Sep 10 15:37:09 EDT 2008 | djmic
I just purchased a soldering station and it came with the silicone grease for the desoldering gun and say's for cleaning spring filter and filter pipe, now do I just smooth this grease all over the spring and tube the spring goes in?
Electronics Forum | Mon Apr 02 11:57:08 EDT 2007 | realchunks
Well, I thing mowing his lawn will get your farther, but if you insist.... Fids - Fiducial registration seems to be a bear with most machines. Especially now that most boards are shipped form over seas, the quality is all over the map. Plus the fa
Electronics Forum | Tue Sep 19 22:45:19 EDT 2006 | darby
Larry, The Quad is based on the Samsung - yes? If so, here are the final recommended answers from Samsung. All LM guides and bearings, ball splines and rack and pinion use Shell Alvania EP2. Sometimes called LF2. Sometimes called Albania. It's a dar
Electronics Forum | Wed Feb 01 00:10:32 EST 2006 | kent
Are you seeing this problem with the nozzles after an error stop? Well check station 15 confirm nozzle clutch origin. It will cause this problem. If you rotate a shaft (with the machine stopped) 45 degrees and start you will get return theta off and
Electronics Forum | Sat Apr 30 14:02:42 EDT 2005 | steve
I'm confused on nozzle rods as a description. Thru-hole desoldering is achieved by fluxing the the leads that are on the bottom side of the board and then coming in with a desoldering gun. You place the tip/nozzle of the gun against the side of the l
Electronics Forum | Wed Jan 31 09:54:52 EST 2007 | FredC
Rob, I am not a Fuji technician, but I have some knowledge on the nozzles, windmills, and headshafts. As far as I know the bore the nozzle travels in should be dry with no lube. The grease on the windmill shaft and locating pin is a special purpose g
Electronics Forum | Tue Jan 31 15:15:13 EST 2006 | russ
Heat guns used improperly will definitely damage components. You must have a controlled heat gun that can be set to the max temp you want pb =215C max, Pbfree maybe 240C max. This heat gun must not be able to be adjusted or you must have total trus
Electronics Forum | Mon Jul 03 23:29:26 EDT 2006 | grantp
Hi, Don't know about your machines, but our XP Fuji machines have a lubrication tube linking the under side of the machine to the top, so you can put a grease gun on it, and push grease into hard to reach places. Does yours have that? If your heari
