Electronics Forum | Mon Dec 26 19:18:49 EST 2005 | arnold
I would to ask on what do you call on the color green contamination found on the soldered units. Whe i soldered some units after few days there was a color green on the wires. what do you call on this contamination?
Electronics Forum | Mon Sep 14 23:10:22 EDT 2009 | linseeg
The PCB green mask will become darker after few times IR reflow? What is the reason? Any acceptance spec refer to green mask requirement? Any method to measure the color level for PCB green mask? By naked eye or machine?
Electronics Forum | Fri Apr 29 09:08:45 EDT 2005 | davef
We call this the "orange stick test", but who's coloring? In preforming the test, you're supposed to use a light touch. Unfortunately, it's difficult to calibrate a "light touch." So, operators often end-up using too much force when probing or usi
Electronics Forum | Tue Jun 21 14:35:11 EDT 2005 | lind
does anyone know how to read SMT zener color code? I need to figure one out that is blue, green, and violet.
Electronics Forum | Fri Jun 07 11:39:33 EDT 2019 | gregoryyork
I feared so. The only thing to be done is to tell the PCB manufacturer to increase the Thermal cure so dont set the oven to 150C but to 170C and actually measure the middle board and once it hits 155C then give it an hour cure from then. Also insist
Electronics Forum | Fri Nov 22 05:04:07 EST 2019 | SMTA-Matthew
We have some circuit boards where the solder mask seems clear instead of green on top of some of the tented via pads. No gold deposited during the ENiG process and no solder sticks to it but why is it clear and does it have any correlation to the thi
Electronics Forum | Thu Jun 19 04:16:11 EDT 2008 | more_sunshine
actually this is my little problem, i don't know about the material except that it comes in a paste form and it has to be diluted with acetone and it has a green color. i wish that the compounds used to make a solder mask aren't that numerous to be d
Electronics Forum | Wed Jun 18 20:27:28 EDT 2008 | davef
No, we not sure if your solder mask is LPI. The article we linked was aimed at solder mask application methods. LPI is the most common mask in use today. So, what kind is it? Green tells you nothing. Solder mask can be a variety of colors.
Electronics Forum | Thu Dec 08 22:25:23 EST 2005 | davef
Grant Copper Oxide [Cu2O]: Color is red to a deep red that can appear almost black. Luster is adamantine or submetallic to dull or earthy if massive. Transparency: Crystals are transparent to translucent. Look here: http://mineral.galleries.com/min
Electronics Forum | Wed Jan 14 08:43:14 EST 2009 | prkonrad
I did not change my mind, I just said that we sat down with the manufacturer and showed them the 3-4 different color PCBs for one product. They agreed that it is not acceptable... and supply us only from one of their sites. (the different manufacturi
.gif)
