Electronics Forum | Tue Jan 23 07:18:24 EST 2007 | cyber_wolf
Hi, We have a UP2000 with grid lok installed on it. We run several assemblies that have component pads close the edge of the board. The side clamps hold the stencil up off the board and we are either getting insufficients or excessive solder paste in
Electronics Forum | Tue Feb 28 11:07:41 EST 2006 | Chunks
Gel Flex works for Dek, just a slight modificaion. Works 100% better than any Grid type of system. We had missprints from Grid Lok and Form Flex - about every 5th or 6th board. Until we modified the Gels, we would take the time and some peelable s
Electronics Forum | Tue Jan 13 18:29:35 EST 2004 | Tom B
I agree with Fastek. Universal tooling is the way to go if you got high changeover. Another option is Grid Loks support system (http://www.grid-lok.com/) Basically remove the ztower and add this system. It'll cost ya about 10K. Get board snugge
Electronics Forum | Tue Feb 28 21:23:45 EST 2006 | Wave Master Larry
Alpha-numeric suck! Just kidding. We had a guy that was in charge of our waves who said the same thing. Never two sure what he meant by that. I've been runnning wave solder for 12 years and them Gels seem to get rid of the broken parts at wave. N
| 1 |
