Electronics Forum | Mon Mar 24 15:20:15 EDT 2014 | kojotssss
Hello for all People's .I have a question. I have a problems with backup pin placement.When x/y robot tried to set up pins: we got a problem- X=-0.200 and y=-0.880 To my mind ther are a problem with air cylinder and axis.Any solutions?! can you c
Electronics Forum | Fri May 25 14:59:45 EDT 2012 | kevslatvin
I too would go with something like the Grid-lock. We use Red-E-sets from production solutions. They are similar to the grid-locks but don't use air.
Electronics Forum | Wed Sep 23 14:00:08 EDT 2020 | emeto
Unless the board is very thin, gridlock type support works fine.
Electronics Forum | Tue Feb 04 14:03:13 EST 2020 | dekhead
As long as pressure is set properly (may require re-adjustment when adding / removing modules) then have not seen / heard of issues with damage to bottom side components. This assuming that rubber tips are in place and in good shape. I have a custome
Electronics Forum | Wed Sep 06 06:12:57 EDT 2006 | jonatf
thanks CL, Any idea how much the Gridlock tooling pin is? Brand new or seconds??? cheers!
Electronics Forum | Wed Aug 23 17:22:39 EDT 2023 | markhoch
I'm curious what you use for PCB Support. Are you using a dedicated support plate or are you using magnetic pins or some type of Grid-Lock system?
Electronics Forum | Tue May 22 09:11:35 EDT 2007 | jola
Hi. We have changed our produktion from high volume to medium/low and have to start hunting change-over time. We have a lot of products with two sides and the settings of pins in the DEK 265 and Fuji QP242 machines when running b-side takes to long t
Electronics Forum | Fri Aug 25 04:43:58 EDT 2017 | praveenmuthusamy
Thank you so much for your valuable feedback . Root cause was found that amount of solder paste printed on board is uneven. Uneven solder paste printing was Due to misalign of backup support pins in PRINTER. Problem was rectified after changing backu
Electronics Forum | Sat Jan 11 17:06:27 EST 2020 | silverlead
I have worked with both Gridlock and conventional pin support mostly on DEK machines. Gridlock allows to reduce greatly changeover time in hi mix/low volume environment when switching sides on double sided boards. It also eliminates guesswork when ma
Electronics Forum | Tue Sep 05 08:40:33 EDT 2006 | CL
SMAINTECH, Good Morning, We have installed the Gridlock tooling pin with stealth mode on our DEK's. It is a hard tooling pin array that resets the height if the pin for every board. The pin comes up until it comes into contact with something then lo
winsouce.jpg)
