Electronics Forum | Thu Feb 24 00:37:08 EST 2022 | joshsvoboda
I have a pcb with an ENIG finish that is using a 144 pin LQFP and being soldered withSN100C/NC258 T4 paste. I used a oven profiler where the probes are taped down to the joint and the profiling software adjusts the program for the best profile for
Electronics Forum | Fri Jun 16 10:38:33 EDT 2000 | Iain
I have 15 very large backplanes (.156" thick Au plating) that the ground pins of a high density thru-hole connector were not thermal relieved in the artwork. As a result we are unable to solder the 8 pins that connect to the ground plane. We know t
Electronics Forum | Sun Dec 08 22:20:39 EST 2002 | grantp
Hi, We have been manufacturing a PCB, however it's been quite tricky to profile, as the edges of the PCB are reflowing before the center of the PCB. I have looked at the design, and there is a small power plane for 2.5 Volt in the center of the PCB
Electronics Forum | Mon Jun 19 19:08:21 EDT 2000 | Brian W.
IPC-610 Rev B: Paragraph 4.1 (page 52), As an exception to fil requirements on Table 4-1 on thermal heat sink planes plated through holes, a 50% vertical fill of solder is permitted, but with solder extending 360 degrees around the lead with 100% wet
Electronics Forum | Fri Jun 16 11:08:30 EDT 2000 | Travis Slaughter
Did you try preheating the board then hand solder? Those little heat shrink guns work great for this.
Electronics Forum | Fri Jun 16 11:28:53 EDT 2000 | Boca
Solder 'follows' heat. 1. Preheating is a great idea, use a baking oven to get the whole assembly up to temperature, use the preheaters in your wave solder machine (without wave) to preheat the assemblies ... 2. Or use the biggest soldering iron
Electronics Forum | Sat Jun 17 08:57:23 EDT 2000 | Chrys Shea
A few more tricks to try: - Got a hot air rework machine? You can get more controlled heat on the area and lower the risk of damage to the fab. I never got topside fillets un unrelieve ground planes until I went to convection preheat on my waves.
Electronics Forum | Tue Feb 10 15:13:06 EST 2004 | patthemack
Hey Vinny, Sorry I haven't looked at this for a while. 3 things to try: Tombstoning- The ground plane side is larger because the solder mask allows for a little slop at the board shop (clearance around a pad of a few mils). Since there is not a defi
Electronics Forum | Thu Jan 29 06:58:40 EST 2004 | davef
Ramp / Soak: Tombstoning is occuring during reflow. You need to get more heat into the ground plane. Obviously a ramp aint gettin' it done. Further, without intending to disrespect your internal discussion, if a linear profile improved the situati
Electronics Forum | Mon Jan 26 03:45:37 EST 2004 | Vinny
Hi All, We are producing a veriety of RF related PCBAs in which we see Unsolder/Mislaigned on a regular basis. In these baords usually one of the pad is connected to a signal trace and the other pad is connected to very huge ground plane. This gro
