Electronics Forum | Fri Aug 12 05:24:35 EDT 2022 | ttheis
We recently parted out a GSM machine that we could not get operational. As parts came off of the machine it looked like the frame would make the world's strongest welding/work table. We stripped the frame bare and flipped it over instead of scrapping
Electronics Forum | Fri Sep 07 17:38:23 EDT 2007 | bentigano
Hello James. I've got a YesTech YTV-2050 system at work with one top-down camera, and 1 side-view camera for each of the four sides. I do have the side view cameras being used for automated side inspection. There are some parts with markings that are
Electronics Forum | Wed Jun 17 01:02:16 EDT 2015 | armandogomez
Hello Had a similar problem way back with the hydra, first go to the service program manually activate the hydra camera then move the Xwagon to place the hydra ref plate over the hydra camera and check first if the camera works, second the image you
Electronics Forum | Fri Jul 16 05:24:40 EDT 1999 | Chris May
| I'm looking into vision inspection equipment to automatically inspect SMD placement and solder joint quality. Does anyone have any recommendations or know of any commonly used equipment? Do other manufacturers use vision systems at their inspecti
Electronics Forum | Mon May 14 03:21:20 EDT 2001 | Eyal Duzy
Phil, In the considerations you make for choosing an AOI tool, you should check what a vendor delivers today and what will it be able to deliver in the future. As the role of AOI in the SMT production line evolves from "detection" to "prevention"
Electronics Forum | Fri Apr 02 15:41:38 EST 2004 | azdback
You may also want to start on the component library. Hypotetically speaking, the GSM shows the component as follows in the component library: One lead to the right, 3 leads to the left. This is the feeder default orientaion and it will be 0 degrees.
Electronics Forum | Tue Dec 15 11:14:40 EST 2015 | ilavu
You can create backup image of your entire hard drive using Acronis TrueImage or ghost. I use acronis and never had any problem. As for the hard drive size, "YOU DON"T HAVE TO BUY OLD USED HARD DRIVE". Size of the new hard drive does not matter if yo
Electronics Forum | Tue Jan 03 14:35:40 EST 2012 | comando
Yes I have this tools and jigs but I can't to complete first calibation (Image camera Y Adjustment) I done all and the nozzle is in the center of display but the machine don't perform this calibration. the nozzle image in display look litle big than
Electronics Forum | Tue Jun 19 10:59:21 EDT 2001 | Gil Zweig
When x-ray inspecting BGA packages with metal heat spreaders tube voltages greater than those used for Plastic BGAs must be used. It must be recognized, however, that the tube votage required will depend on the particular sensitivity of the x-ray cam
Electronics Forum | Thu Aug 13 14:52:42 EDT 2015 | deanott
We just encountered a problem with the vision on our MPM Accuflex. We just switched jobs and when we went through a 'Vision Set-up' there was no image (just blank gray screen where you'd normally see the PCB or bottom of stencil). When we tried to
