Electronics Forum | Tue Jun 28 12:04:07 EDT 2011 | esoderberg
I would agree up until 2005 - 2006. Universal did not have a good SMT solution. Their GSM's were limited and combined with the sanyo chip shooter - software was a nightmare. What years did you have universal?
Electronics Forum | Wed Mar 27 09:57:08 EDT 2019 | dilogic
Yes, you can. However, if you go above designed, limits you might either break something or it won't operate as you expect. There are settings for each servo loop on the machine and you can play with acceleration, speeds etc. Not sure that it's smart
Electronics Forum | Fri Dec 26 23:05:29 EST 2003 | tommy
It can be wrong pressure sensor switch setting,malfunction or low incoming air pressure.If incoming air pressure below the setting limit then 1 block stop message will display on screen.
Electronics Forum | Tue Mar 06 14:27:14 EST 2018 | charliedci
Contact Dan Chretien at Southwest Automation Consultants. He has helped me with our old UIC axial inserter. He has a website.
Electronics Forum | Wed Mar 07 07:55:36 EST 2018 | alpha1
Let me know what model you have. I can probably help. Don
Electronics Forum | Wed Mar 07 14:03:43 EST 2018 | junkeymonkey246
I will attach a photo of the Spec Plate. NO:6241b10465-8-41941603
Electronics Forum | Wed Aug 18 13:12:26 EDT 2021 | oxygensmd
S2 sensor, that is some kind of limit switch as I think. Anyways, you have found the source of issue soooo your machine will back to work soon. :)
Electronics Forum | Thu May 13 17:08:38 EDT 2010 | gregcr
prompt appears hit enter, another prompt should appear. Now set Diagnostic/Run switch to run, start vision system software load. The vision software can not load if the system is in running arbitrary code and hung in a loop so halting the controller
Electronics Forum | Tue Nov 24 13:37:27 EST 2015 | ttheis
A shot of the screen is attached showing the version information. Where do I find the filters? It looks like the power goes from the switch to the large power distribution box which I presume has the back-up batteries inside. What method is recomme
Electronics Forum | Fri May 14 09:34:18 EDT 2010 | lockj69w
This procedure is from UIC's knowledge base. TO run Diagnostics on AISI 3500 vision. Use of this procedure will require reloading of vision executive once complete. 1. verify PC1 COMM2 is connected to COMM2 on the RADISYS board in slot 1 of VME chass