Electronics Forum | Wed Sep 04 10:10:10 EDT 2019 | jameshoward
I know exactly what your problem is as I have seen it many times. Your problem is with indexer 1 (the cylinder which runs up and down and actuates feeders on side 1). At each end of the travel of the indexer is a micro switch hidden down below the be
Electronics Forum | Fri Oct 28 14:09:39 EDT 2022 | ttheis
Allowing a part to go over the board boundaries can cause collisions when boards are nested. The software on these machines has limitations but it is plenty capable and rooted in preventing physical damage to the machine. Once you are familiar with t
Electronics Forum | Tue May 21 08:26:14 EDT 2002 | stefwitt
without knowing your machine, I guess the axis does not find the zero pulse. You may have to re-place the incremental or linear encoder for the X-axis. Some vendors use proximity switches for a zero pulse which could be defective. If the axis stops i
Electronics Forum | Fri May 04 08:53:48 EDT 2007 | davem
I have been working with the UIC GSM platform for 6 years now in an EMS environment. Operating, programming, configuration, and line installation. I do not work for Universal or represent them in any way. UIC is a 1st rate company with excellent and
Electronics Forum | Mon Oct 17 13:02:28 EDT 2016 | tdemon69
i have a MPM2000 now giving me 0 - hardware limit warnings..let me start off by saying that is was giving me x axis limit problems, so i replaced the x card with diff card. set all the switch and jumpers to x card , then i got 0- hardware . so then
Electronics Forum | Tue Jan 09 13:12:16 EST 2001 | rwilliams
I was wondering if there is anyone out there who is still using the HTI AutoPrint Screen Printers who might be willing to share technical support information. We are having trouble with the machine "finding the stencil" and were wondering if anyone
Electronics Forum | Wed Sep 22 13:49:47 EDT 1999 | Claude Couture
The machine is a Universal 6796 DIP inserter. The driver card for the X axis burned a couple of resistors and a trace, probably a couple of power transistors too. I had a spare card and put it in. Now on powering-up the machine, the X-Y table move
Electronics Forum | Thu Oct 16 00:08:31 EDT 2003 | Dean
Why would you have troubles if and when you switch? Isn't that the point of materials evaluation? Understanding the impact and material capability BEFORE "betting the farm on it". I would never stake my career on a solder paste without an Engineer
Electronics Forum | Tue Apr 25 01:23:28 EDT 2006 | kanna
Thanks. currently we already reduce the temperature and change the bimetallic switch. can anyone help me on the alert problem. the alert trigger when the zone 1 section empty without board. current temperature setting is 187 even i lower the tem or i
Electronics Forum | Sat Mar 17 14:14:30 EDT 2018 | introlab
Hi . If the machine was not connencted to power ,the battery failed and the controllers exec was lost or corrupted. Check the bettery on J11 controler ,if it is dead this is the case. Change the battery and reload the exec. There is an exec file