Electronics Forum | Mon Mar 11 13:38:54 EDT 2019 | cyber_wolf
Hi, Does anyone have any experience replacing the rinse valve actuator in a SMT800-ZD ? I think I had one go bad and it looks like you may need to time the new valve. It has cams on the shaft that engage and disengage limit switches. Thanks in adv
Electronics Forum | Thu Mar 02 19:54:51 EST 2023 | oxygensmd
The question is, the motor is working or not? Moves, does anything? Seems to be endswitch not working if moves and you heard beaming sound - like motor moving but its on mechanical endpoint. If I were you, I bet on a limit switch is defective under
Electronics Forum | Fri Feb 13 09:25:35 EST 2004 | jcdupree
Hi Patrick, I can easily troubleshoot ML, EL and SL 20 systems by phone or e-mail, but the MPC-29 is a bit more complex. The problem that you are describing was failry common, and there were a number of potential causes. First is to check if the dr
Electronics Forum | Thu Oct 20 11:39:43 EDT 2011 | swag
Make sure the housing for the switch can move up and down freely (no lose parts/screws and the lead screw is clean and lubed with some light oil). I've had a tactile housing come loose from the lead screw = limit errors - it should be tight with no
Electronics Forum | Mon Oct 13 15:33:36 EDT 2014 | rgduval
So...today, we were able to get rid of the z axis not mounted error. It looks like we did so by modifying the settings in axes location (matched them to the beam 1 settings). Now, when we try to lower the nozzles, we can hear a relay or switch clic
Electronics Forum | Thu Sep 15 10:43:18 EDT 2016 | claudea2
Thanks to Bobpan we re connected our wipe system and all the air actuators work fine. I still have a problem with the cleaner fluid dispenser. It is not moving as it should to dispense the liquid when we do the command. I suspect the values in the c
Electronics Forum | Fri Oct 10 16:23:59 EDT 2014 | dilogic
First, plug all holes with nozzles or plugs. Then use I/O diagnostics to fire changer up and activate vacuum. Then try to remove each of the nozzles and see if the vacuumm holds. If it does, check vacuum detector switch (mounted on changer side). The
Electronics Forum | Tue Dec 22 23:57:21 EST 2020 | ttheis
Ok; is this the 5a box located under and behind the pdp? I see now in the diagram it is labeled pdp1.ps1. Any suggestion for what to check to determine if the problem is the power supply or something connected to it? I noticed that when the 12v po
Electronics Forum | Fri May 01 15:35:03 EDT 2020 | travishemen
I'm not sure if these are similar to our Genesis machines but if they have removable feeder banks they are part of the safety circuit. If they are not installed or if the sensors on them are misaligned it will show the same as an interlock violation
Electronics Forum | Mon Jul 10 13:08:21 EDT 2023 | ttheis
Thanks, I do recall reading about loading firmware onto some of the VME cards (VRM axis controllers I believe.) I will review this again. I agree that it seems to be some issue with reading axis position after hitting the home switch. The first thin