Electronics Forum | Mon Oct 15 14:29:58 EDT 2018 | compit
I have an Emerald X machine (by Assembleon) with an LCS. I start production. The first PCB board runs to the end of the LCS (item 1). Each subsequent stop is BEFORE LCS (item 2) - I have to remove it manually. And so until the production reset - then
Electronics Forum | Thu Mar 24 23:34:55 EDT 2022 | glasscake
My Koh Young 3030VAL errors on the homing routine. The "DTool" "MCS" gives me an error "Before homing, X-AAxis already checked negative limit..." "Before Hoking, Y Axis already checked negative limit..." "Please turn off the control-power-switch, an
Electronics Forum | Fri Mar 29 16:17:47 EDT 2013 | aemery
Sorry I am late on this thread, just became a member and was scanning through the posts. I am a former FSE for Speedline, now independant, so all this stuff is my bread and butter. Here are some facts that could help you all in the future. MPM pri
Electronics Forum | Thu Jun 10 16:23:11 EDT 2004 | davem
Hi Grant, In previous positions I've had experience with the Fuji CP43, CP6, CP642, CP643, CP65, IP3 & QP242. In operating, training and process engineering capacities. Presently, I'm working with 2 SMT lines (in a process engineering capacity) wit
Electronics Forum | Fri Jul 29 17:41:35 EDT 2016 | ddina
I appreciate your response. I kind of read about it, and made sure nothing sensor-wise is activated by mistake on the process of zeroing. Right now the machine is in this set up, and the rear rail is all the way to the back stop. So the sensor on the
Electronics Forum | Wed Nov 27 08:54:03 EST 2019 | ttheis
Hi Tushar, Thanks for the reply. I do believe I put it into debug mode but I will be sure to check next time I try logicomm. I am not using any RAMTF or PTF. At the moment I have upgraded the machine from EPC-5 to EPC-5-66 which I found cheap. The
Electronics Forum | Wed Jan 23 22:49:38 EST 2013 | ercdave1
Asking the great minds with experience for some advise. I am looking to go from placing components with a low quality machine to a low cost production machine. I am tired of inspecting after placement and spending hours aligning the parts with twezer
Electronics Forum | Tue Mar 12 10:16:05 EDT 2013 | bocci572
Yes the components are flat and no larger than 50mm in size. Most are full rings or just an arc of a ring. I understand fully the best way to have the capabilities proven would be to have the vendor demonstrate. I am kind of looking at what people
Electronics Forum | Sat Feb 13 08:03:14 EST 2021 | dilogic
I might answer some of your questions: 1 - in order to use old 24V feeders, Advantis needs 24V feeder kit installed. As far as I figured out, it's only 24V transformer and wiring, so I guess you can do it yourselves if the machine is not upgraded
Electronics Forum | Fri Jun 30 20:59:04 EDT 2006 | johnwnz
Folks, who uses MYData's?.... In a previous life I was a fuji man and liked them I have to say, they were big n heavy and you could drop them from a plan and they would still work... well till they brought out the QP's but lets not go there. I did ha