Electronics Forum | Fri Sep 24 20:33:44 EDT 1999 | Ron Gillam
| | | The machine is a Universal 6796 DIP inserter. The driver card for the X axis burned a couple of resistors and a trace, probably a couple of power transistors too. I had a spare card and put it in. Now on powering-up the machine, the X-Y tabl
Electronics Forum | Fri Oct 09 14:01:24 EDT 1998 | Bob Barr
Charles, I am using an Air-Vac PCBRM12 to selectively solder a 96 pin thru-hole connector onto an otherwise all SMT board. Cost is $8.6K plus about $300 per flow well (nozzle.) Went from a 6 minute cycle to hand solder the connector to 15 seconds o
Electronics Forum | Thu Oct 05 12:52:34 EDT 2006 | Mario Scalzo, SMT CPE
Good afternoon! Typically, we normally recommend testing the pot, and adding either Sn/Ag or just Sn to keep it at bay. One nice thing about the solubility of Cu in Sn based alloys is that it should reach a theoretical upper limit of about 0.1%. I
Electronics Forum | Wed Feb 20 15:21:56 EST 2013 | rmitchell
Hi, hopefully I am too late, it is fixed and you are up and running. Have you tried MPM support on the phone? We have 2 older MPM's and the blow the driver modules in the bottom drawer on the back of the machine. There are different drivers for dif
Electronics Forum | Mon Feb 08 23:16:07 EST 2021 | mendez
Hi, so I was able to turn the machine on for a few seconds. It looks like the IC on the LCD doesn't have goo contact because it's very hard to keep the machine operational. I was able to see the table lifting for the first time; it was so cool! but t
Electronics Forum | Wed Oct 19 07:04:06 EDT 2022 | winston_one
If any changes in design is not possible and you have to solder it, it's a real headache, I know... I see only 3 options here that you can try consiquently: 1) Accurately profile the board and optimize a profile (go to lower limit of process windo
Electronics Forum | Tue Feb 07 11:55:27 EST 2023 | tommy_magyar
What I would look at is the chemicals being used in the facility where the complaints are. Flux/flux gel, IPA, cleaning agents, etc. Perhaps you should limit the usage to certain people only, who would be trained how to properly use these. Something
Electronics Forum | Fri Jul 07 17:17:43 EDT 2023 | ttheis
We swapped the Y1 and Y2 pc800 controllers with no change. We swapped out the UIMC III-I cards from another machine with no change. VRM amps all look OK, no errors. The machine moves the head both in the x and y directions during the zeroing attemp
Electronics Forum | Fri Jul 07 17:33:25 EDT 2023 | jdengler
Since you haven't received any useful advise I will throw my 2 cents in. I do not know this machine but in general what you describe is an axis that does not get it's home pulse in time. Many machines will have an in-range sensor that gets flagged
Electronics Forum | Wed Jun 10 17:30:44 EDT 1998 | FAC
When creating part data�s for BGA or QFP style components, the line scan camera will be utilized (Camera No. 4). Using a Single nozzle type placing head, a nozzle capable of sufficient vacuum, and front lighting the part can achieve placement of a 74