Electronics Forum | Fri Sep 14 19:55:06 EDT 2018 | amartineck
I have a GSM1 that when try to zero it, it stops with the "Timeout waiting for spindle up" message. To get thsi up and running, I have set all my machine settings to default and had to reselect the head from a C4 1 head to the flex head. I initially
Electronics Forum | Tue Sep 05 11:09:09 EDT 2017 | emeto
The message might still be correct. Change the pneumatic cylinder on the nozzle changer - I have seen these to go bad.
Electronics Forum | Tue Sep 05 10:14:41 EDT 2017 | swag
Try a fid teach on your changers. I don't recall how to do it but you'll find it pretty easy if you surf around. Also, the seals on the nozzles must be good and soft. If you can still get them new, I'd replace. Same goes for seals in changers. C
Electronics Forum | Fri Sep 08 22:37:30 EDT 2017 | ttheis
If you have two changers and only one head, make sure there is only one open port (one changer should be filled up and the other should have one open hole.) The head should be full of nozzles as well. As you mentioned go into the diagnostics and act
Electronics Forum | Fri Sep 01 09:54:02 EDT 2017 | gsmx4321
I get a Timeout waiting for nozzle changer vacuum buildup failure every time I go to run my 1998 GSMx machine. The problems seems to be that once in a while (it seems to be random) the spindle does not line up exactly in the center of the nozzle cha
Electronics Forum | Tue Sep 05 14:40:08 EDT 2017 | rgduval
We emailed off forum about this...and I'm wondering how things are progressing. As I noted in email, our issue was the nozzle change was resulting in too many nozzles being out of the same vacuum channel on the tool box. I can't remember how it was
Electronics Forum | Thu Oct 09 17:37:58 EDT 2014 | rgduval
Got a failure while starting up our GSM, and hoping you guys have an easy fix that we're not seeing. We're getting a Timeout waiting for nozzle changer vacuum buildup. It seems to be occurring on head 2, during nozzle change. We've reseated all of
| 1 |
