Electronics Forum | Wed Dec 29 18:01:13 EST 1999 | JAX
What's happenin Larry, I am not sure if bump proccess E is available on this particuliar software rev. but I have forgotten?????? It shouldn't matter; bump proccess A will work fine. The only things you have to do is make sure the pick up point
Electronics Forum | Mon May 11 17:03:05 EDT 2015 | dilogic
Any advice how to (easily) replace theta timing belt on GSM Flex head?
Electronics Forum | Thu Jul 28 17:35:45 EDT 2016 | travishemen
We have similar machines and they will give errors like this if the adjustable sensor on the unload end is over the fixed or movable rail.
Electronics Forum | Thu Jul 28 15:43:48 EDT 2016 | ddina
Recently started setting up our GSM 4681A system, and one of the machines comes up with the message "WAITING FOR OUTPUT BOARD TRANSFER TO COMPLETE" after the Zeroing process has been started. Machine has all the defaults set, two SMEMA connected univ
Electronics Forum | Fri Jul 29 17:41:35 EDT 2016 | ddina
I appreciate your response. I kind of read about it, and made sure nothing sensor-wise is activated by mistake on the process of zeroing. Right now the machine is in this set up, and the rear rail is all the way to the back stop. So the sensor on the
Electronics Forum | Fri Dec 08 13:25:18 EST 2006 | SWAG
We have a heavy carrier that results in belts spinning out when our GSM attempts to transfer it to the centernest. Can the belt transfer speed be slowed down on GSM? How???
Electronics Forum | Mon Dec 11 12:02:34 EST 2006 | SWAG
Got it - Thanks much Mika.
Electronics Forum | Sun Dec 17 18:13:13 EST 2006 | bigdaddysoy9
GLOBAL MEMORY > ALTER MEMORY > MC_READONLY > MC_READONLY [AXIS-ERROR] > ID_MC_READONLY_AXIS_AREA, Then select Axes #9. If you make the changes here, then hit "update", the changes will take effect immediately. Then you can play around and figure out
Electronics Forum | Mon Dec 11 05:30:11 EST 2006 | mika
[Drop down menus] > Machine > Configuration > Parameters > Axes => You are now on a page with 3 menus > on the left side menu [Axis choice] scroll down and mark [Transfer belts] > On the upper right menu [Configurable Values] > mark [Default maximum
Electronics Forum | Wed Jun 17 10:17:12 EDT 2015 | swag
There is. I've done it. Can't remember how the heck to do it 100%, though! We no longer have GSM's and it was years ago so sorry I'm not much help but I'll try. I remember a couple details... I put clear or kapton tape on the part (sticky side u
