Electronics Forum | Tue Feb 09 12:47:56 EST 2010 | swag
Refer to the thread started by Deni on 2/4/10. Your problem is similar.
Electronics Forum | Fri Sep 14 19:55:06 EDT 2018 | amartineck
I have a GSM1 that when try to zero it, it stops with the "Timeout waiting for spindle up" message. To get thsi up and running, I have set all my machine settings to default and had to reselect the head from a C4 1 head to the flex head. I initially
Electronics Forum | Tue Feb 09 08:48:29 EST 2010 | davemacnemo
Machine has 2 FlexJets installed. Working fine until it started giving Theta1 following errors. Machine will not zero. Coincidental (I think) with this, the Low Power Power Supply behind the Power Distribution Panel failed and was rebuilt. It's worki
Electronics Forum | Thu Jul 16 15:09:27 EDT 2015 | goodting
Can anyone tell what Axis controller and VRM-MC board does in GSM machine? Regards
Electronics Forum | Thu Jul 09 13:13:01 EDT 2015 | horchak
Is the y axis sitting on the out of limit switch by chance
Electronics Forum | Wed Jul 08 10:29:14 EDT 2015 | goodting
Dear SMT Specialists Had anyone encountered GSM ADvantis zeroing failure problem? The x-axis is idle while the y-axis is waiting to be activated. My initial guess is either Axis control board or machine configuration conflicts. How to fix it? any le
Electronics Forum | Thu Jul 09 15:17:48 EDT 2015 | goodting
Thanks for the inquiry. We used MCD (Motion Control Dia) tool to verify if that is caused by VRM board. No respond(I means the related axis was off) was detected. we swapped that board to other machine, the VRM card was good.... X axis was stopped, t
Electronics Forum | Tue Jan 29 07:54:47 EST 2019 | anonymus
Hi, I have GSM2 UIC machine, machine does complete zeroing successfully but without scanning feeder plate fiducials. I enabled feeder plates (rear and front), but the problem is identical. Can anyone pls help me?? Thanks
Electronics Forum | Tue Mar 14 17:16:10 EST 2006 | bigdaddysoy9
Yeah, definitely do what BillyD said before you go any further.
Electronics Forum | Fri Mar 17 06:31:07 EST 2006 | geb
Thanks for your help Pitbull, this seems to have resolved our problem. Thank you!
