Electronics Forum | Tue Feb 09 12:47:56 EST 2010 | swag
Refer to the thread started by Deni on 2/4/10. Your problem is similar.
Electronics Forum | Tue Feb 09 08:48:29 EST 2010 | davemacnemo
Machine has 2 FlexJets installed. Working fine until it started giving Theta1 following errors. Machine will not zero. Coincidental (I think) with this, the Low Power Power Supply behind the Power Distribution Panel failed and was rebuilt. It's worki
Electronics Forum | Fri Sep 14 19:55:06 EDT 2018 | amartineck
I have a GSM1 that when try to zero it, it stops with the "Timeout waiting for spindle up" message. To get thsi up and running, I have set all my machine settings to default and had to reselect the head from a C4 1 head to the flex head. I initially
Electronics Forum | Mon Jan 28 13:40:53 EST 2019 | liquidspacie
Hello, I'm trying to fix this error and what I've done so far I cleaned (no scratches) measuring scale and swapped cards (gantry 1 & 2) and cleaned scale reader sensor. There are no spare parts, I'm just trding to narrow down the cause. Any suggestio
Electronics Forum | Tue Mar 22 22:42:18 EDT 2016 | ttheis
Apparently the machine is now completing initialization but when attempting to zero axis' it has a time-out waiting to change modes. Machine status page shows an error reading "initialization failure for motion control board."
Electronics Forum | Wed Mar 23 20:13:19 EDT 2016 | ttheis
UPDATE: For anyone experiencing similar issues it looks like it is bad axis control card(s.) It would make sense since that is what the message said... A red "fail" led was overlooked on one of the cards apparently. I had this same issue with anothe
Electronics Forum | Tue Feb 11 00:21:54 EST 2014 | bren
I suddenly encountered this error F-AXIS-C/9 Error says Axis has unstable zero point. Any advise?
Electronics Forum | Thu Jan 07 18:34:51 EST 2021 | tamcrocker
Hello, I have an UMG VCD-H that is currently stop working due to a message " head Zero switch error" when retracting. I would like to know how to clear this message.
Electronics Forum | Fri Sep 26 12:26:16 EDT 2008 | dwelch123
Isn't that what I just said? Read it again. I said you can swap zero and one OR two and three.
Electronics Forum | Fri Jan 15 12:20:26 EST 2021 | proceng1
It sounds like the homing switch isn't being made when it zeros. Alpha 1 Technologies can probably help. 607-772-2900 That's who we call for VCD issues.
