Electronics Forum | Mon May 10 10:53:20 EDT 2010 | dilogic
Does anyone have some experience with AIS3500 on GSM1? It stopped to function just like that. I've opened it to check the batteries and I can see 4 status LED's blinking in a constant pattern, but I can't get any response over seial line from it...
Electronics Forum | Sat May 15 13:24:17 EDT 2010 | dilogic
That would do if AIS3500 is working in the first place. As explained above, it does not operate correctly. Dead serial lines, jittery video output signals, internal 4 status LED's blinking in a repeating pattern (changing colours at the same time)...
Electronics Forum | Tue Mar 22 22:42:18 EDT 2016 | ttheis
Apparently the machine is now completing initialization but when attempting to zero axis' it has a time-out waiting to change modes. Machine status page shows an error reading "initialization failure for motion control board."
Electronics Forum | Fri Feb 28 09:52:47 EST 2003 | ksfacinelli
One easy and often over looked step is to call out IPC-6012A compliance on the PO. You will also need to call out the class status. If you get in an issue regarding quality you will have a resource to fall back on. Sounds simple but ask your buyers
Electronics Forum | Sun Oct 11 10:00:11 EDT 2015 | brockparry
if you are facing a problem to send the data to your machine then you must check the driver part of your machine if you are sending it through any software. Also check the power status of the machine. You can also go for one simple method by doing Re
Electronics Forum | Wed Jan 06 12:19:30 EST 2021 | oxygensmd
If you get Machine Offline error, that means the backPC non-working or there are some connection issue between front and back PCs. FrontPC is normally a standard PC, backPC normally is a 4U-size industrial PC. I had the same issue in the past, multi
Electronics Forum | Wed Jun 03 21:49:27 EDT 2020 | bboyer
Well, we finally got the machine to power up and fully boot, but now we are having issues with zeroing the axes. X, Y and Theta zero OK, and the board conveyor runs, but when it tries to zero the PWC, the rail moves to the rear of the machine, hits
Electronics Forum | Tue Aug 04 12:11:56 EDT 2015 | bnorton
OS/2 UIC version 3.2.3 Powerup seems to go OK until, while the GUI says ...initializing..., an error popup appears saying "Did not receive request to load machine model within timeout period. Possible machine error condition exists. Do you want t
Electronics Forum | Mon Apr 05 14:26:51 EDT 2004 | mgc
Hi Quanta, Universal serial numbers can be explained by our Technical Support staff. Briefly, serial numbers identify the documentation that the machine was built against, the chronological position within a lot of machines, an Equipment Number descr
Electronics Forum | Thu Feb 04 02:46:39 EST 2010 | dilogic
OK, here we are: 1. OS is OS&2 2. Sw. is USOS V1.14 3. GSM1 4. 2 Flex2 heads 5. Problem is on the front head 6. No 7. No 8. It just stops in the middle of the placement phase, with the head over PCB area. Usually 2 parts are still held on the nozz
