Electronics Forum | Fri Sep 14 19:55:06 EDT 2018 | amartineck
I have a GSM1 that when try to zero it, it stops with the "Timeout waiting for spindle up" message. To get thsi up and running, I have set all my machine settings to default and had to reselect the head from a C4 1 head to the flex head. I initially
Electronics Forum | Fri Sep 01 09:54:02 EDT 2017 | gsmx4321
I get a Timeout waiting for nozzle changer vacuum buildup failure every time I go to run my 1998 GSMx machine. The problems seems to be that once in a while (it seems to be random) the spindle does not line up exactly in the center of the nozzle cha
Electronics Forum | Fri Sep 08 22:37:30 EDT 2017 | ttheis
If you have two changers and only one head, make sure there is only one open port (one changer should be filled up and the other should have one open hole.) The head should be full of nozzles as well. As you mentioned go into the diagnostics and act
Electronics Forum | Mon Oct 31 23:34:30 EDT 2011 | haiae
Dear All, I bought a used Contact 3AVX some months before. The machine run seem be good until last week I meet a problem as follows: - Head one(Left side) does not pick up components (0805 only) any more after pick good about 10 components. Spindles
Electronics Forum | Thu Jul 28 15:43:48 EDT 2016 | ddina
Recently started setting up our GSM 4681A system, and one of the machines comes up with the message "WAITING FOR OUTPUT BOARD TRANSFER TO COMPLETE" after the Zeroing process has been started. Machine has all the defaults set, two SMEMA connected univ
Electronics Forum | Fri Jul 29 17:41:35 EDT 2016 | ddina
I appreciate your response. I kind of read about it, and made sure nothing sensor-wise is activated by mistake on the process of zeroing. Right now the machine is in this set up, and the rear rail is all the way to the back stop. So the sensor on the
1 |