Electronics Forum | Fri Oct 01 00:49:33 EDT 2010 | darrenj
Yes, we have the Agilis stick feeder and it is a definite improvement on the vibe. It usually comes with a set of starter 'tubeforks', but i bought another starter set after a while since the individual tubeforks are relatively expenisive. Always g
Electronics Forum | Thu Aug 19 20:20:16 EDT 2021 | astarotf
Does anyone know why the heads of the GSM2 dual beam 4688 sound like this? When it is in x position the motor begins to vibrate
Electronics Forum | Tue Jan 29 07:54:47 EST 2019 | anonymus
Hi, I have GSM2 UIC machine, machine does complete zeroing successfully but without scanning feeder plate fiducials. I enabled feeder plates (rear and front), but the problem is identical. Can anyone pls help me?? Thanks
Electronics Forum | Thu Oct 04 00:14:21 EDT 2018 | gaintstar
Flason SMT universal products: http://www.flason-smt.com/product/Touch-screen-Manual-stencil-printing-machine-solder-paste-printer.html http://www.flason-smt.com/product/Universal-8mm-CT0892-Feeder.html http://www.flason-smt.com/product/Universal-Gen
Electronics Forum | Thu Aug 20 13:15:58 EDT 2009 | ratsalad
Yes, you should be able to. The feeder interface for the GSMs (not Advantis or Genesis) has been the same as far back as I can remember... And we used to have a D-block machine. We use some of the same feeders from that old D-block GSM on the GSM
Electronics Forum | Sun Aug 07 14:37:50 EDT 2011 | franxsmt
Hi every body, Recently I got a vibration feeder for my SM421 Samsung machine. The feeder has no manual and I don't have any contact with Samsung people. I put the feeder into a feeder slot, the feeder goes on (a red lamp on the feeder indicates it
Electronics Forum | Mon Aug 08 07:45:23 EDT 2011 | geb
Although I don't have the same model machine (ours is Samsung CP45FV) our Vib feeder had a "transportation" screw or strap (it was a few years ago) fitted that you need to remove before it vibrates properly. Ours has a on/ off switch on the feeder
Electronics Forum | Fri Jun 04 14:04:36 EDT 2010 | dedwards
I have a question about assembleon vibration feeders. What is the process for loading tubes in these feeders? Our personnel are cutting the top of a tube end around the size of the part and glueing it into place. Then the machine is programmed for
Electronics Forum | Thu Aug 20 08:42:32 EDT 2009 | voytek
Do you know if I can use Multi Pitch Tape Feeder from GSM2 platform on GSM and GSM1 platform? Thank you,
Electronics Forum | Thu Jul 28 08:16:33 EDT 2005 | grantp
Hi, Your not using vibration feeder here are you? I have seen this a lot with vibration stick feeders. Regards, Grant
