Electronics Forum | Mon Oct 13 11:18:37 EDT 2014 | dilogic
parameters -> axis that z axis for head2 is also enabled ("axis mounted" must be 1)
Electronics Forum | Thu Jul 13 14:21:21 EDT 2006 | bigdaddysoy9
I just had these errors the other day. The problem was the Z axis drive belt was chewed up.
Electronics Forum | Tue Oct 14 07:38:29 EDT 2014 | dilogic
Z axis drivers are located in co-salled LP servo bay. It is 19" rack mounted in lower left part of the machine. Head1 z axis driver is in slot 4 and head2 driver is in slot 6
Electronics Forum | Wed Jul 12 16:39:59 EDT 2006 | SWAG
Can anyone help point me in the right direction on fixing problems related to the following Universal GSM2 errors?: 1) Axis head 1 Z position following error during Move Absolute command. 2) Axis head 1 Z error not recognized during Move Absolute
Electronics Forum | Tue Oct 14 09:22:51 EDT 2014 | rgduval
Deni, Do you know if the theta axis controlled by the same slots/cards as the z-axis, by any chance? We also can't get theta to work on head 2, so, I'm wondering if the issue is related... thanks, ..rob
Electronics Forum | Thu Mar 04 22:52:57 EST 2004 | Roberto Rodriguez
i have a Universal GSM2 machine down and we check all, but are exaust, the problem is the next, when we make Zero axis tha machine say "AXIS HEAD1 Z POSITION ERROR DURING MOVE RELATIVE COMMAND" AND "TIME UP SPINDLES UP". DO YOU HAVE EXPERIENCIES AT T
Electronics Forum | Wed Mar 19 19:19:41 EDT 2014 | dave222
thank you for taking the time to look at this post. hopefully someone can help. I have a GSM2 Q block with a Flexjet 7 spindle head. a couple of days ago the machine encounter this issue while zeroing. the issue is with head 2 on beam 2. on the di
Electronics Forum | Wed Jun 27 02:24:28 EDT 2007 | jola
Check the drive belt first for missing tooth or bad tension. If thats ok you might need to change the clutches, they need to be changed every second year or soo. If they are worn out the wire driving the spindle might slip causing this problem. This
Electronics Forum | Tue Oct 14 09:21:38 EDT 2014 | rgduval
Thanks, Tushar, we might give that a try. The only reason I'd lean away from it is because I've been able to determine that I can't get the nozzles to move down on head 2 in the manual screen (or move the theta). I may be chasing two problems, but,
Electronics Forum | Tue Oct 14 14:08:22 EDT 2014 | dilogic
No, each card in LP servo rack drives only one motor. But there is an servo cotnroller board (actually 3 of them) in the VME rack (where all computers are). Third one from the left(slot13) controls head2 theta and z axis. That might be a cause of you
