Electronics Forum | Mon Jul 08 18:45:53 EDT 2019 | assuredtech
Would you happen to have the Jig used to check that the component itself is in spec with UIC's general specifications? 1.) Component in spec. 2.) Correct 2.5mm pusher on the feeder / dispense head. Also set the conditioner guide where the comp enter
Electronics Forum | Thu Jul 07 19:39:18 EDT 2005 | darby
This is a very difficult question to answer as it will depend greatly on your component mix. I will presume that the CSM 84VZ is of the following configuration: 2 x RDC Synchro Heads. Heads 1 & 2. These are mechanically centering heads with a chucki
Electronics Forum | Thu Jun 18 23:24:12 EDT 2020 | jmelson
About 12 years ago, this forum was hugely helpful in guiding me to get a Philips CSM84, with no vision. (That might have been a mistake.) Now, I'm moving to smaller parts, especially TSSOP and QFP with 0.5 mm pitch, and the CSM just isn't accurate
| 1 |
