Electronics Forum | Wed Feb 23 08:27:14 EST 2011 | cyber_wolf
I am going to disagree with that. Our QP242 wasn't worth a crap when it came to reliably placing BGA's. The lighting parameters and the programming will have you tearing your hair out. If you are doing outline recognition on small BGA's...then maybe.
Electronics Forum | Tue Jun 08 00:14:14 EDT 2004 | primoflyer
BGA and some oddform, high mix....many thanks! Short list: Ass'on Topaz(s); Pana CM/BM; Univ'GSM AdVantis; MyData MY
Electronics Forum | Thu Apr 21 12:48:23 EDT 2005 | imserv
I have a Siemens SP-120 and an HS-180 available. Can the SP-120 be used without a line computer installed? Possibly using the HS-180 computer? We are looking to use the machine for short production runs and prototying. Thanks in advance for an
Electronics Forum | Fri Apr 15 09:10:09 EDT 2005 | Dhanish
The biggest problem I am having is the X-Ray and ICT could not detect this shorts.ICT could not detect because onboard measurement shows Zero even without the Hair line shorts.With Hairline there is no difference in the impedance value for ICT to fai
Electronics Forum | Wed Apr 13 21:47:32 EDT 2005 | Dhanish
In production,we are seeing high defect for Hair Line Solder Shorts for PTH connector and the Hair Line is too tiny that X-Ray and ICT could not detect.Any suggestion on how we can resolve or at least detect this upfront.
Electronics Forum | Mon Nov 08 14:11:41 EST 1999 | Aaron Unterborn
Susan- The Rochester Institute of Technology (RIT) has a fully functional SMT assembly line, less AOI. The web page I attached has a photograph of the line as well as a short description for each piece of equipment. If you would like more information
Electronics Forum | Mon Oct 23 03:52:32 EDT 2017 | wendymm
Hello guys, I'm a new learner in PCB field. And recently, I have summarized some basic information I learnt on how to arrange the line on crystal oscillator, but I'm not sure if it is right. So I'll write it down below, hope anyone who may read my po
Electronics Forum | Thu Dec 09 14:50:35 EST 2021 | emeto
The question is what exactly are you trying to achieve and at what cost? There is not unique recipe to answer this question, cause we don't know what product is running on this line. Sometimes very short line gives us much more throughput compared to
Electronics Forum | Tue Jun 20 19:06:44 EDT 2006 | grantp
Hi, Yes, forget Guru, he's a "tosser" who talks "bolloks". Did you ever notice the English have fantastic words for putting people down? Anyway back to the original question. A manual stencil printer might be ok if your not doing anything too tric
Electronics Forum | Wed May 26 05:58:50 EDT 2010 | chrislyttle
Hi, first time posting on here. We've recently acquired additional Fuji machines to add to our line and have moved premises to a new factory. I've been trying to set up a new factory line in Line Editor to use two of our existing machines (Fuji GSP